Changing Wmrp Soldering Tips - Weller WMRT Manual De Uso

WMRP/WMRT
WARNING!
CAUTION!
PK Elektronik Vertriebs GmbH, E-Mail: [email protected], Internet: www.pkelektronik.com

6 Changing WMRP soldering tips

Risk of burns
The soldering iron becomes hot during soldering and desoldering.
There is a risk of burns from touching the soldering tip.
The soldering tool must stand at least 3 min. in the safety tool
holder (WDH 50) before the soldering tip is cold. Soldering tips
must only be changed when cool.
Removing old tip
1. Place the soldering tool on the tool holder.
Always ensure that the soldering tip is properly seated.
2. Turn the station power switch to "OFF".
3. Wait 3 min. until the soldering tip is cold.
4. Grasp the soldering iron on the soft grip area (4) and pull the
soldering tip from the tool.
Installing a new soldering tip:
Risk of malfunction
The soldering tip must be completely inserted.
Operation with a soldering tip that is not completely inserted can
cause the tip to malfunction.
Ensure that the soldering tip is inserted completely up to the
stop in a single motion.
5. Grasp the soldering iron on the soft grip area (4) and push the
new tip on to the soldering tool.
6. Turn the station power switch to "On" and set the required
temperature on the control.
Note When using several types of soldering tips, it is recommended to
store the tip on the back of the tool stand WDH 50.
9-12