Connecting The Solar Generator - VOLTWERK VC 200 Instrucciones De Servicio

5 Installation
Result
5.3
52
(1) Fan set
(2) Fan set connector
2. Plug in the fan set connector. Please note:
The connector must be plugged in firmly and securely.
|
The fan set is installed.

Connecting the solar generator

Required tools and materials
Torque wrench 19 mm
|
Cable stripping knife, insulation removal tool
|
M12 cable lug. Please note:
|
Cable lugs must be of the correct size for the cable diameters used.
|
Cable lugs must be isolated on the shaft with isolating or shrink
|
tubing.
Cable lug manufacturer's specifications.
|
Permissible tools for crimping cable lugs. Observe local regulations,
|
applicable standards and directives.
Prerequisites
Safety equipment available (see Chapter 2.7.2, page 19).
|
2–8 cable leads available.
|
Up to 4 plus pole strings and 4 minus pole strings can be connected to
each device.
Connecting the solar generator
1. Remove the lower safety cover.
2. Check the cable leads of the solar generator.
Operating manual
Transformerless central inverter
(1)
(2)