Pausing A Nutritional Therapy - Nestle Health Science Compat ella Instrucciones De Uso

Precautions:
• When programming a new therapy, make sure to clear the
• After starting a therapy, verify all therapy parameters (including rate, dose, and volume given this therapy).
Notes:
• Holding or changes values rapidly:
• When setting rate, the value will pause at 1, 50, 125, 250, 600 mL/hr.
• When setting Bolus, the value will pause at 1, 125, 250, 500, 750, 1000, 1250 and 1500 mL.
• Total Volume will also pause at 1, 125, 250, 500, 750, 1000, 1250, 1500, 2000 and 4000 mL.
When at maximum value, pressing
•
The pump will sound the alarm when a programmed volume is completely given or the nutrition container runs out. The
•
may be temporarily deactivated (see 12.).
After each bolus is complete, the pump will display an
•
start. This cycle will continue until the pump is turned off, a defined amount of tube feed is given or the tube feed runs out.

10. Pausing a Nutritional Therapy

Button Result
At any time while the pump is running, you may pause the nutritional therapy by pressing
the pump displays a
• Change the feeding program
• Change the feed container
• Administer medication without switching the pump off
• Silence an alarm and correct problems
Note: After 2 minutes, an alert sounds and the message
mode by an additional 2 minutes.
VOLUME GIVEN THIS THERAPY
again will go to the minimum value and vice versa e.g. rate from 600 mL/hr to 1 mL/hr.
INTERVAL PAUSE
message. Press
PUMP PAUSED
PUMP WAITING
parameter.
and
TIME TO NEXT BOLUS
to resume the nutritional therapy. Use the Pause mode to:
appears in the display. Press to snooze the alarm and to extend the pause
alarm
END OF THERAPY
screen showing when the next bolus will
. The Run icon disappears and
EN
49