Mounting The Loop Handle - Stihl FSA 90 Manual De Instrucciones

Swinging handlebar into transport
position
3
7
Loosen the wing screw (3) and
N
unscrew it until the handlebar (7)
can be rotated.
Rotate the handlebar 90°
N
counterclockwise and then swing
the handles down.
Tighten down the wing screw (3)
N
firmly.
Swinging handlebar into working
position
Reverse the sequence described
N
above to swing the handles up and
turn the handlebar clockwise.
FSA 90, FSA 90 R

Mounting the Loop Handle

Using the Barrier Bar
A barrier bar may have to be mounted to
suit the cutting attachment you intend to
use – see "Approved Combinations of
Cutting Attachment, Deflector, Handle
and Harness".
The barrier bar comes standard with the
machine or is available as a special
accessory.
Mounting Loop Handle with Barrier Bar
2
1
Fit the square nuts (1) in the barrier
N
bar (2); the holes must line up.
4
5
6
Place the clamp (3) in the loop
N
handle (4) and position them both
against the shaft (5).
Position the clamp (6) against the
N
shaft.
Place the barrier bar (2) in position
N
as shown.
Line up the holes.
N
Insert the screws (7) in the holes
N
and screw them into the barrier
bar (2) as far as stop.
Go to "Adjusting and Securing the
N
1
Loop Handle".
English
2
3
7
49