Assembling The Trimmer; Mounting The Handle - Stihl FSA 90 Manual De Instrucciones

English
► If the LEDs glow or flash red: Troubleshooting, @ 19.
Malfunction in trimmer or battery.

7 Assembling the Trimmer

7.1

Mounting the Handle

FSA 90
► Switch off the brushcutter, push the retaining latch to
position and remove the battery.
1
2
4
5
► Remove the wing screw (1).
► Remove the upper clamp molding (2).
► Place the handlebar (3) in the lower clamp molding (4).
► Fit the upper clamp molding (2).
► Insert the wing screw (1).
► Swing the handlebar (3) up.
► Tighten down the wing screw (1).
► Remove the screw (6).
► Position the control handle (7) on the handlebar (3),
trigger facing the gear housing, and line up the hole in the
control handle with the hole in the handlebar.
► Fit the nut (7).
► Insert and tighten down the screw (6) firmly.
52
3
6
3
► Position the throttle cable retainer (10) and the throttle
cable (9) on the shaft.
Do not kink the throttle cable or lay it in tight radii – make
sure the throttle trigger moves freely.
8
► Squeeze the throttle cable retainer (10).
The throttle cable retainer (10) engages in position with an
7 audible click.
The bike handle can be lefton the shaft.
FSA 90 R
► Switch off the brushcutter, push the retaining latch to
position and remove the battery.
► Fit the clamp (4) in the loop handle (3).
► Place the loop handle (3) with clamp (4) on the shaft (5).
► Fit the washers (2) on the screws (1).
► Press the clamp (6) against the shaft (5).
7 Assembling the Trimmer
9
10
1
2
3
4
5
6
7
0458-709-9921-B