Assembling The Trimmer; Mounting The Loop Handle; Mounting Loop Handle With Barrier Bar; Mounting And Removing The Deflector - Stihl FSA 130 R Manual De Instrucciones

English
► If 3 LEDs on the battery flash red while you are checking
the controls: Pull connecting cable plug out of the
socket and contact your STIHL dealer for assistance.
There is a malfunction in the trimmer.
► If you cannot carry out this work: Do not use your trimmer
and contact your STIHL dealer for assistance.

6 Assembling the Trimmer

6.1

Mounting the Loop Handle

► Switch off the trimmer and pull the connecting cable plug
out of the socket.
1
2
6
7
► Fit the clamp (4) in the loop handle (3).
► Place the loop handle (3) with clamp (4) on the drive tube
(5).
► Fit washers (2) on the screws (1).
► Hold the clamp (6) against the drive tube (5).
► Insert screws (1) through holes in loop handle (3) and
clamps (4 and 6).
► Fit and tighten down the nuts (7) firmly.
48
3
4
5
6.2

Mounting Loop Handle with Barrier Bar

► Switch off the trimmer and pull the connecting cable plug
out of the socket.
1 2
► Insert nuts (2) in the barrier bar (1) so that the holes line
up.
► Fit the clamp (5) in the loop handle (3).
► Place the loop handle (3) with clamp (4) and barrier bar (4)
on the drive tube (6).
► Hold the clamp (7) against the drive tube (6).
► Insert and tighten down the screws (8).
6.3

Mounting and Removing the Deflector

6.3.1 Mounting the Deflector
► Switch off the trimmer and pull the connecting cable plug
out of the socket.
6 Assembling the Trimmer
3 4
5
6
7
8
0458-725-9821-C