Cleaning And Maintenance; What If There Are Problems - Beurer BC 28 Instrucciones De Uso

• To clear the relevant user memory, you must first
select a user memory.
• Start the retrieval of the average measured values.
A flashes on the display and the average value of
all saved measured values in this user memory is
displayed.
• Press and hold the memory button M and the
START/STOP button
ing on the user memory you are in.
All values of the current user memory
are deleted and the device switches
off.

8. Cleaning and maintenance

• Clean the device and cuff carefully using a slightly
damp cloth only.
• Do not use any cleaning agents or solvents.
• Under no circumstances hold the device and cuff
under water, as this can cause liquid to enter and
damage the device and cuff.
• If you store the device and cuff, do not place heavy
objects on the device and cuff. Remove the batteries.
for 5 seconds, depend-

9. What if there are problems?

Error Possible cause
message
The systolic or
or
diastolic pressure
could not be
measured.
The systolic or
or
diastolic pressure
is outside of the
measurement
range.
The cuff was
or
not attached
correctly.
33
Solution
Please wait one
minute and repeat the
measurement.
Ensure that you do not
speak or move during
the measurement.
Please wait one
minute and repeat the
measurement.
Ensure that you do not
speak or move during
the measurement.
If the message is
displayed again, you
should seek medical
assistance and check
the accuracy of your
procedure.
Please observe the
information in the
chapter on "Attaching
the cuff".