Cleaning And Maintenance; What If There Are Problems - Beurer BC 54 Instrucciones De Uso

Step 4: BC 54:
Data transfer immediately
following measurements.
• If Bluetooth ® data
transfer has been ac-
tivated, data is trans-
ferred after having
confirmed the user
memory and pressing
the START/STOP but-
ton .
The " beurer Health Manager" app must be active to
allow data transfer.
If your smartphone has a protective cover, remove this
to ensure that there is no interference during the transfer.
Begin the data transfer in the " beurer Health Manager"
app.
We would explicitly draw attention to the fact that the
software to hand is not a medical product in accordance
with EU Directive 93/42/EEC.
The values displayed are purely for visualisation purposes
and must not be used as a basis for therapeutic treat-
ments. The software is not part of a diagnostic-medical
system.
Step 4: BC 54:
Data transfer at a later
point:
• Go to memory mode
(chapter „7. Use", sec-
tion „Saving, displaying
and deleting measured
values"). Select the
desired user memory.
®
The Bluetooth transfer
starts automatically.

8. Cleaning and maintenance

• Clean the device and cuff carefully using a slightly
damp cloth only.
• Do not use any cleaning agents or solvents.
• Under no circumstances hold the device and cuff under
water, as this can cause liquid to enter and damage the
device and cuff.
• If you store the device and cuff, do not place heavy
objects on the device and cuff. Remove the batteries.

9. What if there are problems?

Error Possible
message cause
Unable to re-
cord a pulse.
You have mo-
ved or spoken
during the
measurement.
39
Solution
Please wait one minute
and repeat the measu-
rement.
Ensure that you do not
speak or move during
the measurement.