Kenwood KDC-X798 Manual De Instrucciones página 23

Symptom
"NO SIGNAL"
"SUBSCRIPTION UPDATED
– PRESS ENTER TO
CONTINUE."
"WRONG CODE"
No Bluetooth device is • Search from the Bluetooth device again.
detected. • Reset the unit. ( 3)
Pairing cannot be made. • Make sure you have entered the same PIN code to
• Delete pairing information from both the unit and the
"DEVICE FULL" appears.
Echo or noise occurs. • Adjust the microphone unit's position. ( 13)
• Check the [ECHO CANCEL] setting. ( 15)
Phone sound quality is • Reduce the distance between the unit and the
poor.
• Move the car to a place where you can get a better
• Voice calling method is • Use voice calling method in a more quiet
not successful.
• "N/A VOICE TAG" appears. • Reduce the distance from the microphone when you
• Make sure the same voice as the registered voice tag
"NOT SUPPORT" appears.
Remedy
Make sure the antenna is mounted outside the
vehicle.
Your subscription is updated. Press the volume knob
to continue.
Make sure you have entered the correct pass code.
( 13)
both the unit and Bluetooth device.
Bluetooth device, then perform pairing again. ( 14)
The number of registered devices has reached its
limit. Retry after deleting an unnecessary device.
( 17, DEVICE DELETE)
Bluetooth device.
signal reception.
environment.
speak the name.
is used.
The connected phone does not support Voice
Recognition feature.
Symptom
• "NO ENTRY" appears.
• "NO PAIR" appears.
"ERROR" appears.
"NO INFO" appears.
Sound is being • Reduce the distance between the unit and the
interrupted or skipped
during playback of a • Turn off, then turn on the unit and try to connect
Bluetooth audio player.
• Other Bluetooth devices might be trying to connect to
The connected Bluetooth • Check whether the connected Bluetooth audio
audio player cannot be
controlled.
• Disconnect and connect the Bluetooth player again.
• "HF ERROR XX" appears.
• "BT ERROR" appears.
TROUBLESHOOTING
Remedy
There is no registered device connected/found via
Bluetooth.
Try the operation again. If "ERROR" appears again,
check if the device supports the function you have
tried.
Bluetooth device cannot get the contact information.
Bluetooth audio player.
again.
the unit.
player supports Audio/Video Remote Control Profile
(AVRCP). (Refer to the instructions of your audio
player.)
Reset the unit and try the operation again. If this does
not solve the problem, consult your nearest service
center.
ENGLISH | 23