Tabla de contenido
Idiomas disponibles
Idiomas disponibles
5. Storage
•
Always unplug and wipe down and dry the machine
after use.
•
The machine should normally be stored with the
handle in the fully upright position.
•
Never store the machine with a pad or brush fitted
as this causes distortion, and results in instability during
operation.
•
Store the machine in a dry indoor area only.
6. Maintenance
WARNING - Before undertaking maintenance operations or
adjustments switch off machine and unplug from the electric-
ity supply. In addition safely disconnect the non-earthed pole
of the battery (or by equivalent method). IMPORTANT – All
other servicing and repairs should only be performed by a
Tornado engineer or Authorised Service Agent. IMPORTANT
– Should the machine fail to operate please refer to the fault
diagnosis section in the back of this instruction manual. If the
problem/ remedy is not listed please contact Tornado Cus-
tomer Service Department for rapid attention.
The machine requires minimum maintenance apart from the
following checks by the operator prior to use:
•
Charging cord and plug (11) - Regularly inspect
sheath, plug and cord for damage or loose connection.
•
Body of the machine - Clean with a damp cloth.
•
Motor overload cut-out - All machines are fitted with
an automatic reset motor overload cut-out. The cut-out will
operate to protect the motor from overheating by switching
the machine off when there is excessive friction/resistance
to the cleaning head on the floor. This is usually caused by
the stickiness of the pad or floor. Turn the cleaning pad over
or if both sides are dirty replace with a clean pad. It is not
possible to obtain a good finish on the floor using a dirty pad.
Should the cut-out operate it will reset automatically when
the motor has cooled sufficiently, usually after 15 - 30 min.
7. After sales service
Tornado machines are high quality machines that have
been tested for safety by authorised technicians. It is always
apparent that after longer working periods, electrical and
mechanical components will show signs of wear and tear or
ageing. To maintain operational safety and reliability the fol-
lowing service interval has been defined: Every year or after
250 hours. Under extreme or specialised conditions and/
or insufficient maintenance, shorter maintenance intervals
are necessary. Use only original Tornado spare parts. Use
of other spare parts will invalidate all warranty and liability
claims. Should you require after sales service please contact
the supplier from whom you purchased the machine, who will
arrange service. Repairs and servicing of Tornado products
should only be performed by trained staff. Improper repairs
can cause considerable danger to the user.
9
Tabla de contenido
