General Aspects - GGP ITALY MH 24 Li Manual De Instrucciones

WARNING!: READ THE INSTRUCTION BOOKLET THOROUGHLY
EN
BEFORE USING THE MACHINE. Keep for future reference.
INDEX

1. GENERAL ASPECTS ............................................. 1

2. SAFETY REGULATIONS ........................................ 2
3. GETTING TO KNOW THE MACHINE ..................... 4
3.1 Description of the machine and planned use.. 4
3.2 Safety signs .................................................... 4
3.3 Product identification label ............................. 4
3.4 Main components ........................................... 5
4. ASSEMBLY ............................................................. 5
4.1 Assembly components ................................... 5
4.2 Fitting the HEDGE TRIMMER DEVICE .......... 5
4.3 EXTENSION OF the HEDGE TRIMMER
DEVICE .......................................................... 6
4.4 Removing the PRUNER DEVICE ................... 6
5. CONTROLS ............................................................ 6
5.1 throttle control lever ........................................ 6
5.2 Throttle brake button ...................................... 6
6. USING THE MACHINE ........................................... 6
6.1 Preparation ..................................................... 6
6.2 Safety checks ................................................. 6
6.3 Start-up .......................................................... 7
6.4 Operation :...................................................... 7
6.5 Stop................................................................ 8
6.6 After use ......................................................... 8
7. ROUTINE MAINTENANCE ..................................... 8
7.1 General information ........................................ 8
7.2 Battery............................................................ 8
7.3 Cleaning the machine..................................... 9
7.4 cleaning and lubrication of the cutting means . 9
7.5 Nuts and bolts ................................................ 9
8. OCCASIONAL MAINTENANCE ............................. 9
8.1 Cutting means occasional maintenance ......... 9
9. STORING .............................................................. 10
9.1 Storing the machine ..................................... 10
9.2 Storing the battery ........................................ 10
10. HANDLING AND TRANSPORTATION .................. 10
11. ASSISTANCE AND REPAIRS ............................... 10
12. WARRANTY COVERAGE ..................................... 11
13. MAINTENANCE TABLE ........................................ 11
14. TROUBLESHOOTING .......................................... 12
15. ATTACHMENTS ON REQUEST ........................... 13
15.1 batteries ....................................................... 13
15.2 Battery charger............................................. 13
1. GENERAL ASPECTS
1.1 HOW TO READ THE MANUAL
Some paragraphs in the manual contain
important information regarding safety and
operation and are emphasized in this manner:
NOTE or IMPORTANT These give details
or further information on what has been
previously indicated and aim to prevent damage
to the machine or cause other damage.
The symbol highlights danger. Failure to
observe the warning can lead to the risk of
injury to oneself and others and/or damage.
The paragraphs highlighted in a square with
grey spots indicate the optional characteristics
not on all models documented in this manual.
Check if the characteristic is on this model.
Whenever reference is made to a position on the
machine "front", "back", "left" or "right" hand side,
this refers to the operator's working position.
1.2 REFERENCES
1.2.1 Figures
The figures in these instructions for
use are numbered 1, 2, 3, etc.
The components indicated in the figures are
identified with letters A, B, C, and so on.
Reference to component C in figure
2 is indicated with the wording: "See
fig. 2.C" or simply "(Fig. 2.C)".
The figures are given as a guide only.
The actual pieces can differ from
those illustrated in this document.
1.2.2 Titles
The manual is divided into chapters and
paragraphs. The title of paragraph "2.1 Training" is
a sub-title of "2. Safety regulations". References
to titles or paragraphs are marked with the
abbreviation chap. or par. and the relevant
number. Example: "chap. 2" or "par. 2.1.
EN - 1