Makita EB5300TH Manual De Instrucciones Original página 19

1
► 1. Idling adjusting screw
Checking throttle valve
If the control cable is bent or caught, the throttle valve
does not contact with the idle adjusting screw, and it
prevents the engine from proper idling. In such a case,
reposition the control cable to ensure proper valve
movement.
► 1. Throttle valve 2. Idling adjusting screw 3. Control
cable 4. Throttle valve stopper
If the throttle valve does not touch the throttle valve
stopper even you pull the throttle trigger fully or if the
throttle valve does not touch the idling adjusting screw
while idling, turn the cable adjusting bolt as follows:
1. Loosen the fixing nut.
2. If the throttle valve does not touch the throt-
tle valve stopper, turn the cable adjusting bolt
counterclockwise.
If the throttle valve does not touch the idling adjusting
screw, turn the cable adjusting bolt clockwise.
1
4 3 2
19 ENGLISH
1
► 1. Cable adjusting bolt 2. Fixing nut
3. Tighten the fixing nut to fasten the cable adjusting
bolt.
4. Check the movement of the throttle valve. The
throttle valve comes to the position as illustrated when
the throttle trigger/lever is pulled/turned.
Cleaning carburetor cover
If the carburetor cover gets dirty and it is difficult to
check the throttle valve, clean the carburetor cover as
follows:
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like for cleaning the carburetor
cover. Otherwise it may be tarnished.
1.
Pass a slotted screwdriver through the hole on
the engine cover. Release the clamp of the carburetor
cover.
2