Safety Instructions Relating To Op- Eration; Safety Notes For Rechargeable Battery And Charger; Installation; Installing Guide Wheel (02) - AL-KO Easy Flex MB 2010 Manual De Instrucciones

Installation

3.1.4 Safety instructions
relating to operation
■
Always operate the machine
with two hands.
■
Always keep hands and feet
away from the cleaning brush,
particularly when switching on
the motor.
■
Wait until the cleaning brush
comes to a stop after switch-
ing off the motor.
■
Remove residues only when
the motor and brush have
come to a stop and the re-
chargeable battery has been
removed.
■
Always keep the guard plate,
brush and motor free of resi-
dues.
■
People who are not familiar
with the appliance should
practice handling it while the
motor is turned off.
3.2 Safety notes for
rechargeable battery and
charger
Heed the safety instructions for
the rechargeable battery and for
the charging unit in the separate
operating instructions.
See:
■
Operating instructions
442228: Li-ion rechargeable
battery B50 Li, B100 Li
442608_a
■
Operating instructions
442230: Charging unit C30 Li
4 INSTALLATION
WARNING!
Danger if assembly is not carried out
completely!
Operation of an incompletely assembled
appliance can result in serious injury.
■
Only operate the appliance when it
is fully assembled.
■
Do not insert the battery into the ap-
pliance until it is fully assembled.
■
Check that all safety and protective
devices are in place and functioning
correctly before switching on.
4.1

Installing guide wheel (02)

1. Insert (02/a) the guide wheel (02/1) into the
brush head (02/2) until it engages.
4.2

Installing guard plate (03)

1. Place the guard plate (03/1) onto the brush
head (03/2).
2. Secure the guard plate (03/1) on the brush
head with the screws provided (03/3).
4.3

Installing guide handle (04)

1. Push guide handle (04/1) onto the telescopic
handle (04/a).
2. Insert threaded bolt (04/2) into the guide han-
dle (04/b).
3. Place (04/c) the rotary knob (04/3) onto the
threaded bolt (04/2) and tighten.
4. Tighten the rotary knob so that the height of
the guide handle can be adjusted with little
effort.
4.4

Installing brush (11)

1. Place (11/a) brush (11/1) onto the drive shaft
(11/2). Make sure that the brush is seated
correctly on the drive shaft.
2. Insert pin (11/3) into hole (11/4) of the drive
shaft and hold with one hand.
3. Position nut (11/5) and tighten.
4. Tighten the nut with the wrench (11/6) in the
other hand.
5. Remove pin and wrench.
27