Installing/Removing The Battery Pack; Operating The Blower - EGO LB5750E Manual Del Operador

APPLICATION
EN
You may use this product for the purposes listed below:
◾
Clearing hard surfaces such as driveways and
walkways.
◾
Keeping decks and driveways free from leaves and
pine needles.
NOTICE:
The tool is to be used only for its prescribed
purpose. Any other use is deemed to be a case of misuse.
ASSEMBLING/REMOVING THE BLOWER TUBE
◾
To Assemble (Fig. B)
Align the groove and push the tube onto the blower
housing until you hear a "click".
◾
To Remove (Fig. C)
Press the tube-release button and pull the tube out.
ASSEMBLING/REMOVING THE BLOWER SPREAD
NOZZLE
◾
To Assemble(Fig. D)
Align the groove in the spread nozzle with the tube
knob and push the nozzle onto the tube until it snaps
into place.
◾
To Remove(Fig. E)
Press and hold the nozzle-release button to disengage
the latch, then pull the nozzle straight from the blower.

INSTALLING/REMOVING THE BATTERY PACK

NOTE:
For best performance, we recommend use of
the EGO 56V Battery BA2240E (4.0 Ah) or any EGO 56V
battery with higher capacity.
Charge before first use.
◾
To Install (Fig. F)
Align the battery ribs with the mounting slots and press
the battery pack down until you hear a "click".
◾
To Remove (Fig. G)
Depress the battery-release button and pull the battery
pack out.
WARNING:
Always take care to note the location of
your feet, children, or pets when pressing the battery-re-
lease button. Serious injury could result if the battery
pack falls. NEVER remove the battery pack when in a high
location.
10
56 VOLT LITHIUM-ION CORDLESS BLOWER — LB5750E
STARTING/STOPPING THE BLOWER (Fig. H)
◾
To Start
1. Depress the air-speed trigger and the blower will begin
to run.
2. To lock the blower on, move the air-speed-trigger lock
toward the back of the tool. The blower runs at higher
speeds as the lever is moved further back.
3. The air-speed-trigger lock can also be pulled back to
start the blower without needing to first depress the
air-speed trigger.
◾
To Stop
1. If the air-speed-trigger lock lever is not engaged,
release the air-speed trigger to stop the blower.
2. If the air-speed-trigger lock is engaged, move the lever
to the OFF position to stop the blower.

OPERATING THE BLOWER

◾
To keep from scattering debris, blow around the outer
edges of a debris pile. Never blow directly into the
center of a pile.
◾
To reduce sound levels, limit the number of pieces of
equipment used at any one time.
◾
Use rakes and brooms to loosen debris before blowing.
In dusty conditions, slightly dampen surfaces when
water is available.
◾
Conserve water by using power blowers instead
of hoses for many lawn and garden applications,
including areas such as gutters, screens, patios, grills,
porches, and gardens.
◾
Watch out for children, pets, open windows, or freshly
washed cars, and blow debris safely away.
◾
After using blowers or other equipment, clean up!
Dispose of debris properly.