Air Turbulation Strips & Vent; Sediment Trap Assembly; Manual Shut Off Valve, Hose & Regulator Assembly - L.B.White Oval 80 HP Instrucciones Y Manual Del Propietario

Air Turbulation Strips
& Vent
Both strips are factory installed into the
oval tube. At installation, ensure strips
are snugly fit into oval tube and do not
extend past end of tube.
REGARDLESS OF TUBE DESIGN:
-- Ensure the green clip is installed on the exhaust
vent. See Fig. 9.
-- Insert the exhaust vent to the end of the last tube.
-- Push the exhaust vent until the tube is stopped
at the rivet.
FIG. 9
GREEN
CLIP

Sediment Trap Assembly

Assemble the tee, nipple, and cap to the nipple at the
gas inlet of the heater. See Fig. 10. Use a wrench to
hold the pipe nipple when installing the sediment trap.
Tighten securely. The sediment trap assembly must
always be mounted in a vertical position. Check all
connections for gas leaks using approved gas leak
detectors.
FIG. 10
NIPPLE
TO GAS CONTROL VALVE INLET
Oval 80 Radiant Tube Heaters
Manual Shut-off
Valve, Hose &
Regulator
1. Assemble the components together. See Fig. 11.
This view shows general assembly of the compo-
nents. The regulator must always be mounted so its
vent, regardless of location on the regulator, is al-
ways pointed downward. Ensure hose is positioned
away from the heater.
2. Tighten all connections securely and check
for gas leaks
FIG. 11
REGULATOR VENT
TO CONTROL
VALVE INLET
TEE
NIPPLE
CAP
Owner's Manual • Oval 80
15
REGULATOR
NIPPLE
VALVE, MANUAL
SHUT-OFF
GAS HOSE
ADAPTER
SEDIMENT TRAP