General Installation Instructions - L.B.White Oval 80 HP Instrucciones Y Manual Del Propietario

10
Oval 80 Radiant Tube Heaters
FIG. 4
REAR VIEW

General Installation Instructions

1. Read all safety precautions and follow L.B. White
recommendations when installing this heater. If during
the installation of the heater, you suspect that a part is
damaged or defective, call a qualified service agency
for repair or replacement.
2. A qualified service agency must check the heater upon
installation and periodically. This shall consist of the
following:
-- Start up and shut down of the heaters to test for proper
operation.
-- Leak check all gas pipe joints and gas hose
connections.
-- Gas pressure checks.
-- Ensuring the heater is properly positioned away from
combustible materials.
3. Heater installation must take into consideration proper
hanging height to allow for clearance of catching ma-
chines, litter spreaders, and any other equipment used.
Owner's Manual • Oval 80
DRAWING INLET AIR THROUGH SIDEWALLS
4. Ensure the heater installation does not inter-
fere with water, gas, or electrical lines.
5. Position the gas hose to prevent any contact
with the tubes, heat reflectors, and burner
box.
6. Ensure that all accessories that ship with the
heater have been removed from shipping
containers and installed. This pertains to gas
hose, regulators, supports, hangers, etc.
7. This heater requires a regulated gas supply
to its gas inlet :
-- The regulator must be the proper design for
the application.
-- The regulator must control the inlet pressure
to the heater within the range specified on the
dataplate.
-- Regulators mounted outside must be pro-