Tabla de contenido
Know What the Presser Feet Will Do
o Check the Presser
Foot
The presser feet are an important feature of this machine.
You need to know
what each foot does in order to use them effectively.
Your presser foot is held in ptace by a foot holder.
Each presser foot merely
snaps on the foot holder, which +sseidom removed.
If you need to remove or attach the foot holder, here is what you do:
To Remove:
FOOl
)
To Remove:
Turn the screw toward the back of
the machine.
Use the large screw
driver.
To Attach:
f
Presser b_.)_
+
•-,,_,._
j
To Attach:
1. Match the hole in the loot holder
with the threaded hole in the
presser bar.
2. Fit the foot holder screw into the
hole.
3, Tighten
the screw
by turning
it
toward you.
o Change the Presser Foot
Use the correct presser foot for the stitch you wish to sew, Consult the Stitch
Pattern Chart and the detailed directions tor sewing with the various presser
feet.
To Snap Off:
f-
f
i
J
"N
To Snap Off the Presser Foot:
1. Raise the needle bar to its highest
position by turning the hand wheel
toward you,
2+ Raise the presser foot.
3. Press
the snap-on
button
on the
back of the foot holder,
The presser foot will drop off.
Snap*on
button .,.
To Snap On:
f
J
Groove
ptr_
To Snap On the Presser Foot:
t. Place the presser foot so the hori-
zontal pin on the foot lies iust under
the groove of the foot holder.
2. Lower the presser foot holder to lock
the presser foot in place,
NOTE:
If you do not hear the presser
foot snap
in place,
press
down
on the presser
toot
hofder firmty until you hear
the snap.
13
Tabla de contenido
