Tabla de contenido
Know What the Presser Feet Will Do
• Check the Presser Foot
The presser feet are an important feature of this machine.
You need to know
what each foot does in order to use them effectively.
Your presser foot is held in place by a foot holder.
Each presser foot merely
snaps on the foot holder, which is seldom removed.
if you need to remove or attach the foot holder, here is what you do:
To Remove:
Foot
holdet_%
\_;,k.
SCreW
To Remove:
Turn the screw toward the back of
the machine.
Use the large screw
driver.
To Attach:
f
/J
P_esser b_
_
J
To Attach:
1. Match the hole in the foot holder
with the threaded hole in the
presser bar.
2. Fit the foot holder screw into the
hole.
3. Tighten
the screw
by turning
it
toward you.
,, Change the Presser Foot
Use the correct presser foot for the stitch you wish to sew, Consult the Stitch
Pattern Chart and the detailed directions
for sewing with the various presser
feet.
To Snap Off:
F
}
To Snap Off the Presser Foot:
1. Raise the needle bar to its highest
position by turning the hand wheel
toward you.
2. Raise the presser foot.
3. Press the snap-on
button
on the
back of the foot holder.
The presser foot will drop off.
To Snap On:
.....
J
To Snap On the Presser Foot:
1. Place the presser foot so the horn
zontal pin on the foot lies iust under
the groove of the foot holder.
2. Lower the presser foot holder to ]ock
the presser foot in place,
NOTE;
If you do not hear the presser
foot
snap
in place,
press
down
on the presser
foot
holder firmly until you hear
the snap,
13
Tabla de contenido
