Tabla de contenido
Changing
Needle
Q Needle clamp screw
(_) Pin
(_ Needle clamp
[]
Turn off the power switch.
Raise the needle to its highest position by turning
the handwheel counterclockwise,
toward you, and
lowering the presser foot
Loosen the needle clamp screw (_) by turning it
counterclockwise.
Remove the needle from the needle clamp (_)
[]
Insert a new needle into the needle clamp_--) with
the flat side to the rear.
When inserting the needle into the needle clamp (_),
push it up as far as it goes° Tighten the needle clamp
screw 0 firmly by turning it clockwise.
[]
To check for a good needle, place the flat side of
the needle onto something flat (needle plate, glass,
etc.)
The gap between the needle and the flat surface
should be consistent. Never use a bent or blunt
needle.
A damaged needle can cause permanent snags
or runs in knits, fine silks and silk-like fabrics.
[]
[]
D
J
[]
To Remove and Attach the Foot Holder
_)
Thumb screw
(_) Foot holder
Presser bar
[]
To remove:
Remove the thumb screw 0
by
turning it counterclockwise
with a screwdriver.
[]
To attach: Match the hole in the foot holder (_) with
the threaded hole in the presser barQ.
"_ghten the
screw (_) by turning it clockwise_
Changing Presser Foot
0
Snap-on button (red button)
(_ Groove
(_ Pin
[]
To remove:
Raise the needle to its highest position by
turning the handwheel counterclockwise.
Raise the
presser foot, and press the red button 0 on the back of
the foot holder.
[]
Toattach:
Place a selected presser foot so the pin (_) on
the foot lies just under the groove (_ on the foot holder.
Lower the presser bar to lock the foot in place_
r
[]
10
Tabla de contenido
