Set-Up And Adjustment; Contracture Footrest (Optional) - Zippie IRIS Manual De Usuario

Set-up and Adjustment

NOTE: Setting the wheelchair on a table or on a flat surface,
such as a workbench, helps make these procedures easier.
NOTE ON TORQUE SETTING: A torque setting is the optimum
tightening which should be made on a particular fastener. A
torque wrench which measures in./lbs. should be used when
tightening fasteners on Zippie wheelchairs. Unless otherwise
noted, use a torque setting of 60 in./lbs. When setting up this
wheelchair.
SWING-AWAY HANGERS AND FOOTRESTS 60°, 70°, 70°V,
80°, OR 90°
1. Installation
a. Place swing-away pivot saddle (A) into the receiver (B) on
front frame tube with the footrest facing outward from frame.
b. Rotate the footrest inward until it locks into place on locking
bolt (C).
2. Removal
a. To remove footrest, push release latch (D) toward the frame.
b. Rotate footrest outward and lift.
3. Height Adjustment with Extension Tube
a. Remove both bolts (E) in the hanger frame tube.
b. Reposition footrest height.
c. Re-tighten all bolts (E).
4. Height Adjustment, Front Mount
a. Loosen and remove the retaining bolt (F) in the frame tube.
b. Position footplate upward or downward in predrilled holes on
hanger tube.
c. Reinsert bolt (F) and tighten.
HEAVY-DUTY, LIFT-OFF FOOTRESTS (OPTIONAL): 70°,
80°, 90°
1. Installation:
Slide pivot saddle (A) into receiver (B) on front frame tube
until it locks into place.
2. Removal:
To remove footrest, push release latch (C) while lifting up
footrest from receiver.
3. Height-Adjustment, Front Mount
a. Loosen and remove the retaining bolt (D) in the footrest
mounting bracket.
b. Position footplate upward or downward in predrilled holes on
hanger tube.
c. Reinsert bolt and tighten.

CONTRACTURE FOOTREST (OPTIONAL)

1. Lateral Mount:
Can be mounted laterally as shown in illustration (E).
2. Center Mount:
Can be mounted in the center as shown in illustration (F).
16 ZIPPIE IRIS