Height Adjustment; Removing The Seating Shell - Zippie JCM Hi-Lo Base Manual De Instrucciones

JCM HI - LO BA SE
B. HEIGHT ADJUSTMENT
NOTE - The height adjustment can be made safely with the child secured in
the seating assembly. Always lock the caster wheels before attempt-
ing to adjust the Base height.
1. Raise the seating platform
a. Step on the height adjustment lever(A) and pump the lever several
times to increase the height of the base.
b. Repeat this process until the preferred height is reached.
2. Lower the seating platform
a. Using your foot, lift up on the height adjustment lever (A). This will
release the pressure in the gas spring, and lower the seating platform.
b. Continue to use your foot to provide an upward force on the adjust-
ment lever, push the platform down to the desired height.
C. INSTALLING THE SEATING SHELL
Always lock the caster wheels before attempting to add or remove the seat-
ing system.The seating assembly should NEVER be installed with an occupant.
The seating assembly should always face forward when mounted on the JCM
Hi-Lo Base.
a. Make sure the seat is in the fully upright position
(no recline or tilt)
b. Make sure the base is in the home position (no tilt).
c. Line up the alignment tag(B) with the corner of the mounting plate (C)
on the base.
d. Lower the assembly so that the seating shell and mounting plate are in
contact.
e. Slide the seat backwards evenly. You should hear an audible click.
f. Check the secure engagement to the baseplate by pulling up on both
sides. If it does not move or tilt, the seating shell is now locked and
has been installed properly.
g. Once locked into place, add the occupant for transportation and/or
adjustment.
D. REMOVING THE SEATING SHELL
Always lock the caster wheels before attempting to add or remove the seat-
ing system. The seating assembly should NEVER be removed with an occu-
pant. Make sure the occupant is moved to a safe location when seperating
the seating shell and base.
a. Make sure the seat is in the fully upright position
(no recline or tilt)
b. Pull and hold release lever (D) so that it disengages from the receiver,
slide the seating shell forwards and lift the seating shell from the base.
c. The seating shell is now ready to be inspected and/or stored.
3
4
5
WARNING
6
WARNING
5
V. OPERATING INSTRUCTIONS
C
3
4
5
6
MK-100068Rev. A