How To Remove Battery Tray Components - Zippie IRIS Manual De Usuario

Ocultar thumbs

100

Tabla de contenido

Idiomas disponibles

Battery Tray

Please Refer To Figures A and B Overleaf.

WARNINGS!

•

Read the User's Manual before installing the battery tray

components onto the wheelchair.

•

Never use this wheelchair as a seat in a motor vehicle

unless all components are removed from the battery tray,

and properly secured separately in the vehicle.

•

Always contact Technical Service before installing or

removing the battery tray components to obtain the correct

assembly locations of the strut tubes, roller carriage

•

assembly and caster brackets.

•

Do not install the battery tray components onto wheelchairs

when the user weighs more than 150lbs.

NOTE: This option is only compatible with wheelchairs having a

minimum floor-to-seat height of 15".

NOTE: The battery tray components are not compatible with

the Attendant Wheel Lock option.

HOW TO MAKE WHEELCHAIR WIDTH ADJUSTMENTS

NOTE: The (2) strut tubes supplied with the battery tray kit

create one unique wheelchair width.

Please contact Sunrise Medical to acquire strut tubes for other

wheelchair widths.

1. Loosen and remove the bolts (A) from both ends of the two

battery tray strut tube mounts (G)

2. Loosen bolts from both ends of the front strut tube.

3. Remove the battery tray.

4. Adjust the width of the chair.

5. Loosen and remove nuts and bolts (D) from the battery tray

mounting brackets (E) on both strut tubes (F).

6. Remove Bolts and nuts (B) and replace the old battery tray

strut tubes with the required size to match the desired width

of the chair.

7. Insert the strut tubes (F) back into the battery tray mounting

brackets (E), replacing bolts and nuts (D).

8. Fasten strut tube mounts (G) onto new battery tray strut

tubes, replace and tighten the bolts (B). Heads of bolts

should be on top.

9. Put the battery tray with the strut tubes back into place,

replace and tighten bolts (A) into both ends of all strut tubes.

NOTE: Use a torque setting of 96 in-lb when tightening struts,

carriages and axle plates.

Battery Tray

HOW TO ADD THE BATTERY TRAY KIT

1. Loosen and remove the bolts (A) from the rear strut tube.

The existing rear strut tube will not be used in the battery tray

setup.

2. Relocation of carriage (when needed, consult customer

service)

a. Loosen and remove rear bolt (i) from the carriage on each

side.

b. Loosen and remove front bolt (ii) from the carriage on each

side.

c. Set the carriage at desired location

d. Replace and tighten bolts

3. Relocation of Axle Plates (when needed, consult customer

service)

a. Loosen and remove front and rear bolts from the axle plate

on each side, noting the orientation and holes used on the

axle plate.

b. Set the axle plate at new location

c. Replace and tighten bolts. Be sure to use the same

orientation and holes in the axle plate as were being used

previously, unless a seat height adjustment is being made.

4. Loosen bolts from both ends of the front strut tube.

5. Place Battery Tray with new middle and rear battery tray

struts in proper locations (consult customer service for proper

locations).

6. Replace and tighten bolts (A) into front strut tube and middle

and rear strut tube mounts (G).

NOTE: Use a torque setting of 96 in-lb when tightening struts,

carriages and axle plates.