Stroller Handle Extension (Optional); Reclining Back; Frame Depth - Zippie IRIS Manual De Usuario

Set-up and Adjustment
FLIP-DOWN BACK FUNCTION
a. To fold the back down, pull-up the back release pins (A) and
push the backrest forward.
b. To lock it back in position, lift the backrest firmly until it locks
in its original position.

STROLLER HANDLE EXTENSION (OPTIONAL)

Installation
a. Press button (B) on the stroller handle so that release pins
are drawn inside the tube.
b. Insert the tube into the back tube receiver (C) until the
release pin protrudes through the receiver mounting hole.

RECLINING BACK

The dual trigger reclining mechanism is installed by Sunrise.
1. To Recline or Raise Backrest
a. Depress both triggers (D) at the same time. Releasing the
triggers positively locks the backrest in place within its 45°
range.
b. To lock out the adjustment system, insert the locking pin (E)
into the trigger holder. Always lock the dual trigger reclining
mechanism securely in place after positioning the backrest.

FRAME DEPTH

1. Back adjustment
a. Loosen and remove the front bolt (F) located in front of back
mounting plate.
b. Loosen and remove the rear bolt (H) from the back mounting
plate.
c. Repeat both steps on the other side.
d. Slide the backrest along the seat rail to the desired position.
e. Replace and tighten the front bolt (F) and the rear bolt (H).
f. Repeat on the other side.
IMPORTANT NOTE: The adjustment on each side of the chair
should be exactly equal.
2. Hanger Receiver Adjustment
a. Loosen and remove the socket head screws (A) from the
seat rail.
b. Slide the hanger receiver (B) in the seat rail to the desired
position.
c. Replace and tighten the socket head screws.
d. Repeat on the other side.
IMPORTANT NOTE: These adjustments may also require
re-positioning the carriage over the base frame,
refer to matrix in the ordering guide for recommended location.
NOTE: Depending on the original position of the hanger
receiver and the amount of adjustment required, a new set
of seat tubes may be required. Holes in the hanger receiver
should not be visible past the front of the seat tube.
22 ZIPPIE IRIS
H
F