User Interface; Basic Navigation; Main Screen; Wash Programs - Hedson W10 Manual Del Usuario

10.

USER INTERFACE

10.1 BASIC NAVIGATION

- The display shows four software defined options in the
bottom field.
- To adjust values, use the operation buttons. Usually the
furthest right is ENTER or NEXT, and the left is BACK or
CANCEL.
- You can always abort by pressing the STOP-button.

10.2 MAIN SCREEN

Water Door
change open
indicator
Time

Wash programs

230312-EN rev.5 2016-09-21
W10 & W12
AutoStart Heater
activated active
SUV wheel
activated
Error
warning
10.3 WASH PROGRAMS
- Start a wash cycle by
pressing one of the
operation buttons
- The machine will start and
display the chosen wash
cycle together with a wash
icon. When washing is
finished, blowing (or
optional CleanRinse) will
start.
- After air blowing is finished,
a checkmark will appear. This
indicates that the wash cycle
is finished.
- PLEASE NOTE: If 300
washes are exceeded,
a warning will flash
alternately with the
checkmark after finished
washing cycle.
- The machine will also
remind the user of
checking water level
since this is important
for the wash
performance. This is
done by flashing an icon
of the water level
indicator alternately
with the checkmark.
10.4 EDIT WASH SETTINGS
The wash programs are editable,
both wash time and air blow
time. Hold the wash program
button pressed down for 3 sec for
the program that should be
edited. The screen WASH
SETTINGS will show up. Increase
or decrease the time with the
operation buttons.
Increasing the Clean Rinse-time
should be done with caution. A
longer time will consume more
tap water.
9