Functions On The Control Panel - Hedson W10 Manual Del Usuario

9.

FUNCTIONS ON THE CONTROL PANEL

2.
4.
2.
9.1 LCD DISPLAY
9.2 AUTO START
If the same program is frequently used, it is possible to
automatically start that wash program.
Load the wheel into the machine and close the door. Activate
AutoStart. The AutoStart icon will now show up in the LCD
indicating that AutoStart is active. Start the wash program you
wish to be used for AutoStart. Next time the door is closed, the
machine will automatically repeat this program.
The AutoStart will repeat the wash program, until AutoStart
button is pressed again.
9.3 SHOTMEDIUM COLLECTION
The water should be changed every 300 wash cycle. To do this,
press the ShotMedium collection button to collect the beads.
MACHINES WITHOUT WATER CLEANING: Press the
ShotMedium collection button. The machine will automatically
start collecting the ShotMedium. See chapter 11 for instructions
of changing the water.
8
W10
1.
4. 2. 4. 2. 4. 4. 4.
3. 7.
5.
W12
1.
4. 4. 4.
7.
5.
2.
6. 3.
W10 & W12
MACHINES EQUIPPED WITH WATER CLEANING: If your
machine is equipped with the water cleaning kit, there are
two choices after the ShotMedium collection button has been
pressed.
You can now choose between ShotMedium collection and
water cleaning. The ShotMedium collection is pre-defined.
By starting this, just press ENTER again. See chapter 11 for
instructions of changing the water.
After the ShotMedium collection is finished, the water cleaning
icon will be pre-marked. Press ENTER to start this session, or
BACK or STOP to abort.
PLEASE NOTE: Always turn off the main switch before
emptying out the water in the machine!
9.4 OPERATION BUTTONS
Operation buttons for choosing Wash Programs, and navigate
in the Settings Menu.
9.5 STOP
STOP Aborts wash programs and takes the user to main screen
from settings.
9.6 STD/SUV WHEELS (W12 ONLY)
The machine is default set at wheel dimensions up to 20".
Washing wheels larger than 20", or SUV-wheels, press the
button. An icon showing that SUV-mode is activated will now
show up in the LCD.
In SUV-mode, the dynamic arm will make a larger sweep to
clean the bigger rim area. The SUV-mode will automatically
cancel after four wheels have been washed.
If you wish to cancel the SUV-mode, just press the
button again. The STD/SUV icon up in the LCD will now
disappear and the machine is optimized for standard
wheels.
To keep the SUV mode, press the button during 4 sec.
9.7 SETTINGS
The Settings mode enables you to view and change advanced
system parameters. Thanks to our sophisticated control system
in this wheel washer many settings can be altered. This is
normally not a part of the everyday use.
To enter settings, press the button on the user panel.
230312-EN rev.5 2016-09-21