Stopping The Engine; Lifting The Generator; High Altitude Operation - Ryobi RY906300LP Manual Del Operador

 Press the start button to start the engine.
NOTE: The battery may require charging before the gen-
erator can be started using only the engine switch. The
generator can be started by pulling the recoil starter grip.
Once the generator is started, the battery will charge as
the unit runs.
 The generator can also be started by pulling the recoil
starting grip until the engine runs.
NOTE: Do not allow the grip to snap back after starting;
return it gently to its original place.
 Allow the engine to run for 15-30 seconds, then move
the choke lever to the RUN position.

STOPPING THE ENGINE

See Figure 19.
To stop the engine under normal operating conditions:
 Remove any load from the generator.
 Turn the engine switch OFF ( O ).
 Close the cylinder valve completely.
To stop the unit quickly in an emergency:
 Turn the engine switch OFF ( O ).
 Close the cylinder valve completely.
WARNING:
While operating and storing, keep at least 3 feet of clear-
ance on all sides of this product, including overhead.
Allow a minimum of 30 minutes of "cool down" time
before storage. Heat created by muffler and exhaust
gases could be hot enough to cause serious burns and/
or ignite combustible objects.
OPERATION
MOVING THE GENERATOR
See Figure 21.
 Disconnect any equipment that is plugged into the
generator.
 Turn the engine switch OFF ( O ).
 Allow 30 minutes of "cool down" time before storing the
machine.
 Raise the handle to the up position.
 For security, insert the pin to secure the handle before
transporting.
 Tilt the machine away from you until it balances on the
wheels, then roll the machine to the desired location.

LIFTING THE GENERATOR

See Figure 22.
 Turn the engine switch OFF ( O ).
 Fold the handle to the down position. Never lift or carry
this product using the handle.
NOTE: This tool is heavy and requires several people to
lift. To avoid back injury, keep your knees bent and lift
with your legs, not your back, and get help when needed.

HIGH ALTITUDE OPERATION

Your engine is configured for operation below 2,000 feet
altitude at the factory. Your engine must be reconfigured for
operation above 2,000 feet altitude. Operating the engine
with the wrong engine configuration at a given altitude may
increase its emissions, decrease fuel efficiency, degrade per-
formance, and cause irreversible damage. Engines configured
for high altitude operation cannot be operated in standard
altitude conditions. A qualified service center should ensure
that your engine is properly configured for your location.
Page 18 — English