Connecting The Vacuum Sawdust Extraction Device; Changing A Saw Blade; Installing And Setting The Riving Knife - Parkside PHKS 1450 LASER Instrucciones De Utilización Y De Seguridad

Preparing for use
Material
Hard­ and softwood (solid
wood) cut longitudinally and
transversely
Plywood, hard fibre board
Chipboard
Blockboard, laminated wood
Coated and veneered board
PVC board
Acrylic glass panels, Plexiglas
Aluminium board
Aluminium profiles
Plasterboard
Mineral wool board
Cement­bound chipboard
The circumferential speeds at minimum and maxi­
mum rotational speeds are approx.:
Setting Rpm
1 1.800
6 5.000
Make sure that the cutting speed resulting from the
effects of different saw blades, materials and the
force you apply to advance the saw is always less
than the circumferential speed (CS) under no load.
Connecting the vacuum
Q
sawdust extraction device
j
Insert the adapter for vacuum sawdust removal
into the sawdust removal connector.
24
j
Connect a vacuum device approved for the
extraction of sawdust and splinters.

Changing a saw blade

Q
WARnInG!
Press the spindle lock only after
the mains plug has been pulled out of the socket!
42 GB/MT
PHKS_1450_Content_LB5.indd 42
1. Then remove the guide fence
Speed
the wing screw
setting
2. Set the cutting depth (by means of the wing
6
screw for cutting depth setting clamp
the minimum position, 0 mm.
3. Swing back the automatic blade guard
6
and place the device down.
4. Press the spindle lock button (until it engages)
6
and release the clamping screw
6
Allen key. Now remove the clamping screw
6
with integral washer head
ing flange
3­5
5. Detach the saw blade.
2­4
6. The installation of a sawblade is done in the re­
4­6
verse order.
7. Press the spindle lock button
4­6
es) and tighten the clamping screw
1­2
the Allen key.
1­2
1­2
must agree with the arrow showing the direction of
rotation (running direction shown on the device).
j
Ensure that the saw blade is suitable for the
saw spindle speed.
Metres/ sec
20
Installing and setting the
Q
riving knife
55
knife
than 5 mm. If the riving knife has been removed e.g.
for a plunge cut, this distance must be observed
again when the riving knife is reinstalled (see Fig. F).
Removing the riving knife: (see Fig. E)
1. Release the wing screws of the cutting depth
setting clamp
up until it meets the stop; this exposes the riving
knife mounting
2. Screw out the mounting screws
the riving knife
cut the riving knife
the circular saw is used for any other sawing tasks.
.
10
21
(see Fig. D).
20
WARnInG!
The arrow on the saw blade
WARnInG!
The distance between the riving
and the saw blade must not be greater
16
and swing the circular saw
5
.
22
.
16
WARnInG!
After completion of the plunge
must be reinstalled before
16
by releasing
12
) to
5
6
using the
21
and the clamp­
(until it engag­
3
using
21
and remove
23
30.07.2008 15:15:25 Uhr