Secret Code Setting And Remote Monitor Function - Daewoo DTC-450 Manual De Instrucciones

ENG

SECRET CODE SETTING AND REMOTE MONITOR FUNCTION

 Setting
1. In on-hook state, press and hold HOLD/RING key for 3 seconds, LCD displays Pin ----.
2. Input a 4-digit of PIN using the numerical keys.
3. Press DEL to edit the secret code, press SET to confi rm.
4. When the last digit of secret code is #, the telephone will activate remote monitor function.
5. Set the ringing volume to dB0. (Please refer to section "SETTING RINGING TONE").
 Usage
1. Secret code: When caller calls this telephone, he/she will hear the usual ringing tone (when the
line gets through) three or four times from telephone line. However, the telephone unit will not
ring. Then the caller will hear a short "di" sound, which means that the caller need to key in the
secret code. Once the caller keys in the correct code, the telephone unit will ring. Press key or
pick up the handset to have the conversation with the caller.
2. Remote monitor: If the last digit of the secret code is #, after the caller keys in the correct
secret code, the telephone unit will go into hands free mode automatically. The caller can hear
the sound around the telephone unit.
3. If the caller keys in the wrong code, he/she will have to call again and key in the correct secret
code PIN.
Note: This function is useful only when the telephone ringer is set to OFF. The caller must know
the secret code in order to dial through the line.
TRANSFER BETWEEN PARALLEL PHONES
 Set paging number
1. In on-hook state, press and hold SET key, LCD displays EL--
2. Key in "*" and the paging number (example "*1"and "*2" ), using DEL key to edit
3. Press SET key to confi rm and exit.
 Transfer the line from paralleled phones:
When a call comes, use one of paralleled phones to answer. Press "*" and the paging number that
was set in another telephone unit (the operation should be done within 30 seconds after you
answer the call using the parallel phone. If the time is more 30 seconds, the transfer operation is
not available), the unit rings, pick up its handset or press key to answer the incoming call.
Notes:
1. Please use same series phones to transfer as above operation. Any special services starting
with "*" off ered by your Telephone company may not function properly.
2. To get the best eff ect of this function, you should load the batteries before using.
ANTI-DIAL FROM PARALLEL PHONES FUNCTION
1. In on-hook state, press and hold #/= key for 3 seconds, LCD displays SPI OFF
2. Press #/= key again, LCD displays SPI ON
3. Press SET key to confi rm
When the anti-dialing is set to ON, users who want to dial using an extension (parallel phone) via
the same line will hear a "DI-DI, DI-DI" beep continuously and will not be allowed to make a call.
18