Tabla de contenido
Cleaning
th e Sh uttle Race
This area must be kept free of dust, lint and
oceasiona! tangled thread. Clean the shuttle race area
about every three months.
, Cleaning
the shuttle
area
(_ Bobbin case
(_ Levers
Shuttle race cover
(_ Shuttle
Shuttle race
(_ Center pin on the shuttle
Raise the needle bar to its highest point and remove the
bobbin case_1_.
Push shuttle race levers _ aside. Lift shuttle race
cover_
and take shuttle(_ out.
Clean the shuttle race _ with a lint brush.
Put a drop of oil on the center pin of the shuttle (_ and
shuttle race_.
Do not over oil.
S
,
Replacing
the shuttle
assembly
Levers
Shuttle race cover
(_ Shuttle
(_ Shuttle race
Center pin on the shuttle
(_ Shuttle driver
Pointed hook
® (oil here)
Turn handwheel so that shuttle driver (_) is forming half
moon on the Ief[ side of the machine.
Hold shuttle_
by center pin (_ and position shuttle so as
to form a half moon on the right side. The pointed hook
will be on the bottom.
Place shuttle race cover (_ into place over shuttle
assembly.
Snap the levers (_ back into the original position.
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii 'iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
66
Tabla de contenido
