Cleaning The Shuttle Race; Cleaning The Shuttle Area; Replacing The Shuttle Assembly - Sears Kenmore 85.12314 Manual De Instrucciones

Cleaning the Shuttle Race
This area must be kept free of dust, lint and occasional
tangled thread Clean the shuttle race area about every three
months
• Cleaning the shuttle area
(3"_Bobbin case
(_) Levers
_) Shuttle race cover
(_ Shuttle
_3) Shuttle race
(_) Center pin on the shuttle
0 Shuttle driver
® Pointed hook
(_) (Oil here)
1, Raise the needle bar to its highest point and remove the
bobbin case (_,,
2. Push shuttle race levers (_) aside. Lift shuttle race
cover (_ and take shuttle Qout
3, Clean the shuttle race 0 with a lint brush°
4. Put a drop of oil on the center pin of the shuttle (_) and
shuttle race(3)_ Do not over oil.
. Replacing shuttle assembly
(_) Levers
(_ Shuttle racecover
Q Shuttle
(_) Shuttle race
(_) Center pin on the shuttle
0 Shuttle driver
® Pointed hook
_b (Oil here)
1., Position shuttle race (_) as illustrated so that the shuttle
driver 0 is forming haft moon on the left side of the
machine_
2 Hold shuttle (_) by center pin (_ and position shuttle so as
to form a haft moon on the right side. The pointed hook (_)
will be on the bottom,,
3. Place shuttle race cover (_) into place over shuttle
assembly.
4, Snap the levers (_) back into the original position.
I I
0
J
64