Cleaning The Shuttle Race; Cleaning The Shuttle Area; Oreplacing Shuttle Assembly - Sears Kenmore 385.15108200 Manual De Instrucciones

Cleaning the Shuttle Race
This area must be kept free of dust, lint and tangled thread_
Clean the shuttle race area every three months.
, Cleaning the shuttle area
0 Bobbin case
Levers
(_) Shuttle race cover (_) Shuttle
(_) Shuttle race
(_ Center pin on the shuttle
1o Raise the needle bar to its highest point, and then
remove the bobbin case 0
2o Push the shuttle race levers (_) aside_ Lift out the shuttle
race cover(_) and take the shuttle (_out.
3o Clean the shuttle race Q with a lint brush.
4. Put a drop of oil on the center pin of the shuttle (_ and
the shuttle race _). Do not over oil.
° Replacing shuttle assembly
(_) Levers
_) Shuttle race cover
(_ Shuttle
(_ Shuttle race
(_ Center pin on the shuttle
0 Shuttle driver
(_) Pointed hook
(_ (Oil here)
1 Turn the handwheel so that the shuttle driverO forms a
half moon on the left side of the machine_
2., Hold the shuttle (_ by its center pin (_), and position the
shuttle so that it forms a half moon on the right side. The
pointed hook will be on the bottom°
3. Put the shuttle race cover (_) back into place over the
shuttle (_) assembly_
4. Snap the levers (_) back into the original position,
®
®
6O