Tabla de contenido
Programación
[SENSe]:VOLTage
{[1]|2|3|4}[:DC]
:RANGe:OFFSet
[SENSe]:VOLTage
{[1]|2|3|4}[:DC]:RANGe
:PTPeak
[SENSE]SWEep:OFFSet
:TIME
SYSTem:COMMunicate
:SOCKet:{[1]|2]}:ADDRess
SYSTem:COMMunicate
:SOCKet:{[2]}:WIFI
SYSTem:DATE
(Command/Query)
The VOLT{[1]|2|3|4}:RANG:OFFS <offset|MAX|MIN|UP|DOWN> command sets the vertical
offset of the time representation of the selected signal.
<offset> is a value in NRf format, it may be followed or not by a multiple and the unit.
By default the value is expressed in volt.
To the question V{[1]|2|3|4}:RANG:OFFS?, the instrument returns the vertical offset of the
selected signal.
Response format:
<measured value><NL>
value in format <NR3> expressed in volt.
(Command)
The VOLT{[1]|2|3|4}:RANG:PTP <sensitivity|MAX|MIN|UP|DOWN> command
sets the full screen vertical sensitivity of the selected channel.
<sensitivity> is a value in NRf format, it may be followed or not by a multiple and the unit.
By default the value is expressed in volt.
To the question VOLT{[1]|2|3|4}:RANG:PTP?, the instrument returns the full screen vertical
sensitivity of the selected channel.
Response format:
<measured value><NL>
value in format <NR3> expressed in volt.
If 10mV/div is the sensitivity displayed in the channel parameters, then the <sensitivity>
parameter = 8 x 10 mV/div.
(Command/Query)
The SWE:OFFS:TIME <time|MAX|MIN|UP|DOWN> command sets the horizontal offset of the
trace (run-after-delay or postrig).
<time> is a signed value in format <NRf> ; it may be followed or not by a multiple and by the
unit.
By default, it is expressed in second.
To the question SWE:OFFS:TIME?, the instrument returns the current run-after-delay.
Response format:
<measured value><NL>
value in format <NR3> expressed in second.
(Command/Query)
The SYST:COMM:SOCK:{[1]|2]}:ADDR "<IPaddress>" command defines the IP address of
the instrument.
Use index 1 to set ETHERNET and index 2 to set WIFI.
<IPaddress> is a chain of characters as: ip1.ip2.ip3.ip4, each of the ipX values must be
included between 0 & 255.
To the question SYST:COMM:SOCK:ADDR? the instrument returns the value of the current IP
address.
Response format: <ip1.ip2.ip3.ip4><NL>
(Command)
SYST:COMM:SOCK <"ssid">, <wep|wpa-psk|open>, <"password"> is used to set WIFI :
the 3 parameters necessary to connect to the WIFI network.
(Command/Query)
The SYST:DATE <NR1>,<NR1>,<NR1> command sets the date of the instrument.
The possible values are:
0
to
9999 for the year range (1st range).
1
to
12
for the month range (2nd range).
1
to
31
for the day range (3rd range).
To the question SYST:DATE?, the instrument returns the date.
Response format:
< YYYY,MM,DD ><NL>
with Y = year, M = month, D = day.
95
Tabla de contenido
