Solving Operational Problems - Haier HCW2460AES Manual Del Usuario

Cakes high in middle with
crack on top
Piecrust edges too brown

SOLVING OPERATIONAL PROBLEMS

Before calling for service, check the following to avoid unnecessary service charges.
Oven Problem
E008 Error appears in
the display window.
Other E Error appears
in the display window.
The oven display
stays OFF
Cooling fan continues
to run after oven is
turned off
Oven door is locked
and will not release,
even after cooling
Oven is not heating
Oven is not cooking
evenly
Oven temperature is
too hot or too cold
Oven light is not
working properly
Oven light stays on
•
Oven temperature too high
•
Baking time too long
•
Pans touching each other or oven walls
•
Incorrect rack position
•
Pan size too small
•
Oven temperature too high
•
Edges of crust too thin
Problem Solving Steps
A problem with latch mechanism occurred. Remove
power and turn it back on again after a few seconds. The
oven should run a latch auto–test. If condition persists,
note the code number and call an authorized service
center.
Remove power and turn it back on again after a few
seconds. If condition persists, note the code number and
call an authorized service center.
Turn off power at the main power supply (fuse or breaker
box). Turn breaker back on. If condition persists, call an
authorized service center.
The fan turns off automatically when the electronic
components have cooled sufficiently.
Turn the oven off at the circuit breaker and wait a few
seconds. Turn breaker back on. The oven should reset
itself and will be operable.
Check the circuit breaker or fuse box to your house.
Make sure there is proper electrical power to the oven.
Make sure the oven temperature has been selected.
Check oven calibration. Adjust calibration if necessary
(see To Set Temperature). Refer to cook charts for
recommended rack position. Always reduce recipe
temperature by 25 °F (15 °C) when baking with
Convention Bake mode.
The oven thermostat needs adjustment. See Calibrating
Oven Temperature.
Replace or reinsert the light bulb if loose or defective.
Touching the bulb with fingers may cause the bulb to
burn out.
Check for obstruction in oven door. Check to see if hinge
is bent or door switch broken.
35