Status Commands - Sony HSR-X200 Manual De Instrucciones

Status Commands

Status acquire command
STATUS SENSE (D7H)
(Effective only in one-to-one communication with the
specified device)
Acquires the status of the recorder.
CMD
TxD D7H
RxD d1
Bit Meaning
d1 7 00: Play stop, 01: Still-picture, 10: Play
6 11: Menus
5 1: Alarm recording area full
4 00: Stop, 01: Pre-alarm recording
3 10: Alarm recording, 11: Use prohibited
2 1: Normal recording area full
1 00: Recording stop, 01: Normal recording
0 10: Timer recording, 11: Timer recording standby
d2 7 Playback modes 00: Normal, 01: Alarm
6 10: Storage 11: Reserved
5 Fixed at 0
4 1: Forward 0: Reverse
3 Playback speed 00H to 0FH
2
1
0
d3 7 1: Channel selected
6 Reserved
5 Reserved
4 Reserved
3 Channel number 00H to 0FH: channel 1 to 16
2
1
0
d4 7 Reserved
6 Reserved
5 Reserved
4 Reserved
3 Reserved
2 Reserved
1 Reserved
0 Reserved
d2 d3 d4 d5
d5 7 Reserved
6 Reserved
5 Reserved
4 Reserved
3 Reserved
2 Reserved
1 Reserved
0 Reserved
Status information send commands
(Effective only in broadcast transmission)
These commands are to occasionally send information
of the recorder.With these commands, you can send
one byte of data following each command. These data
must be in the range of 00H to EFH. F0H to FFH are
forbidden.
STATUS LOG-1 (BFH)
CMD
TxD BFH
RxD
Bit Meaning
7 1: Warning
6 1: Normal recording area full
5 1: Alarm recording area full
4 Reserved
3 Operating mode (listed below)
2
1
0
Bit
Operating mode
3 2 1 0
0 0 0 0 No mode change
0 0 0 1 Play Stop
0 0 1 0 Still-Picture
0 0 1 1 Forward Slow Play
0 1 0 0 Backward Slow Play
0 1 0 1 Forward Play
0 1 1 0 Backward Play
0 1 1 1 Forward Run
1 0 0 0 Backward Run
1 0 0 1 Normal Recording Stop
1 0 1 0 Normal Recording
1 0 1 1 Timer Recording
1 1 0 0 Timer Recording Standby
1 1 0 1 Alarm Recording Stop
d1
69
(GB)