Setting Up The Scales - Adam Equipment ABK Serie Manual De Usuario

EN
3.3

SETTING UP THE SCALES

• Remove the base and pillar from the packaging and place the
pillar into the base fitting. Fix the pillar by using the 2 x screws
provided. Remove the circular ring from its bag and place on top
of the pillar with the slot at the top and making sure the cable runs
through it. Fasten the ring to the pillar using the screw provided.
• Remove the bracket that is fixed to the Indicator with the 2 x
locking handles and position it onto the circular ring part. Ensure
that the gland around the cable is fitted into the slot in the ring.
• Fix the bracket to the ring part using the 4 x screws provided and
then re fit the Indicator to the bracket.
• Adjust the viewing angle of the Indicator to the ideal position and
tighten the 2 x locking handles.
• Plug the cable connector into the socket on the rear of the
Indicator marked LOAD CELL and tighten.
• Level the scale by adjusting the five feet on the ABK or the four
feet on the AFK. If the scale rocks re-adjust the feet.
• Attach the power to the indicator and press the [On/Off] key. The
software revision number will be displayed followed by a self-test
showing all digits before the zero is displayed along with the unit
of weight that was last used.
© Adam Equipment Company 2015 6 3116611621RevA1-Feb15