Setting Up The Scales; Display Windows - Adam Equipment AZ extra Serie Manual De Instrucciones

EN
2.2

SETTING UP THE SCALES

• The scales come with a stainless steel platform, packed separately.
• Place the platform in the receptacles on the top cover.
• Do not press with excessive force as that could damage the load cell
inside.
• If an optional scoop has been supplied, place it on top of the platform.
• If an optional display on Pillar is supplied, install the pillar in the upright
position into the socket at the rear of the scale by carefully pushing the
cable inside the pillar rod. Secure the pillar rod to the socket by using
two M4 screws. A black plastic cap is provided to seal the socket from
the bottom to avoid damaging the cable.
• Level the scale by adjusting the four feet. The scale should be
adjusted such that the bubble in the spirit level is in the centre of the
level and the scale is supported by all four feet.
• Turn the power ON using the switch located on the right side of the
base.
• The unit will display the software revision number in the Weight
window and count down to zero while performing a self-test.
• When ready all three displays will show zero.
2.3

DISPLAY WINDOWS

© Adam Equipment Company 2011
Not applicable for South Africa and Far East
4