GE JGBS09 Manual Del Propietario E Instrucciones De Instalación página 35

3 ELECTRICAL CONNECTIONS
B
Usage Situations where Appliance Power Cord
will be Disconnected Frequently.
Do not use an adapter plug in these situations
because disconnecting of the power cord places
undue strain on the adapter and leads to eventual
failure of the adapter ground terminal. The customer
should have the 2-prong wall receptacle replaced
with a three-prong (grounding) receptacle by a
qualified electrician before using the appliance.
The installation of appliances designed for
mobile home installation must conform with the
Manufactured Home Construction and Safety
Standard, Title 24 CFR, Part 3280 (formerly the
Federal Standard for Mobile Home Construction
and Safety, Title 24, HUD, Part 280) or, when such
standard is not applicable, the Standard for
Manufactured Home Installations, latest edition
(Manufactured Home Sites, Communities and
Set-Ups), ANSI A225.1, latest edition, or with
local codes.
Electric Disconnect
• Locate disconnect plug on the range back.
• Pinch sides of connector and pull out of range back.
4 SEAL THE OPENINGS
Seal any openings in the wall behind the range
and in the floor under the range when hookups are
completed.
ASSEMBLE SURFACE BURNERS
5
CAUTION:
Do not operate the burner
without all burner parts in place.
A
Assemble the side burners as shown.
Side
Grate
Burner cap
Burner head
Electrode
Installation Instructions
(CONT.)
35
ASSEMBLE SURFACE BURNERS
5
B
Assemble the center burner. Make sure that the
locking feet on the center grate hook over the
side grates.
Center Grate
Locking
Foot
Burner head
and cap
assembly
C
Replace the burner heads and caps. Make
sure that the heads and caps are replaced in the
correct location. There is one oval (center) head
and cap assembly and four side heads and caps.
For model JGBS80:
Medium burner Oval head and cap
head and cap assembly
Front of range
Large burner
head and cap
For model JGBS09:
Oval head and cap
Medium burner
assembly
head and cap
Front of range
Medium burner
head and cap
Make sure the slot in the burner head is
positioned over the electrode.
Slot
Electrode
Make sure that the heads and caps are replaced
in the correct locations.
(CONT.)
Locking
Foot
Electrode
Small burner
head and cap
Extra large
burner head
and cap
Medium burner
head and cap
Medium burner
head and cap
Slot