Bosch GRL 500 H Instrucciones De Funcionamiento página 26

of the relative height display 32 shows how
much the laser receiver has to be moved
downwards.
If the audio signal is switched on, a rapid
beep is heard.
– Move the laser receiver downwards in the
arrow direction.
When the center mark 16 is approached,
only the tip of the direction indicator 40 is
shown.
Laser receiver centered: If the laser beam
runs through the reception area 26 at the
height of the center mark 16, then the center
line indicator 43 lights up. If the audio signal
is switched on, a continuous beep is heard.
If the measuring tool is moved so that the
laser beam leaves the reception area 26
again, the most recently displayed direction
indicator 39 or 40 will flash for approx. 5 s.
TM
Strobe Shield Protection
The laser receiver has electronic filters for
strobe light. The filters protect against, for
example, interference from the warning lights
of construction machinery.
Marking
When the laser beam runs through the center
of the reception area 26, its height can be
marked at the center mark 16 left and right of
the laser receiver.
When marking, ensure the receiver is
held vertically (when using the unit with a
horizontal laser beam) or horizontally (when
using the unit with a vertical laser beam)
so the marks are perfectly aligned with the
beam.
RF Communication between Measuring
Tool and Remote Control/Laser Receivers
If a wireless connection is established
between measuring tool and laser receiver,
the laser receiver acts as a remote control.
All other laser receivers can only receive the
laser beam.
– Switch off the measuring tool and the
laser receiver.
– Dock the laser receiver in the charging/
storage station 6.
– Press the On/Off button 17.
2610A16816.indd 26
Settings such as measuring accuracy or
audio signal can be set individually for each
laser receiver.
If the remote control/laser receiver is
switched off, the measuring tool switches off.
All other laser receivers each have to switch
off separately.
Note: Sleep mode of the measuring tool can be
deactivated only by pressing the sleep mode
button 21 on the remote control/ laser receiver.
Setting the Audio Signal/Volume
/
The position of the laser beam on the
reception area 26 can be indicated via an
audio signal.
You can choose between two volumes or
switch off the audio signal.
The default setting in the delivery condition is
[Normal audio signal].
The setting for audio signal/volume is saved
when the tool is switched off.
Selecting the Setting of the Center Line
Indicator
You can specify the accuracy with which the
position of the laser beam is indicated as
"centered" on the reception area.
The default setting in the delivery condition is
[Measuring accuracy "medium/3 mm"].
-26-
– The RF communication indicator
33 is displayed to indicate the
remote control function on the laser
receiver.
/
If the RF communication is lost, the
RF communication indicator 33
/
flashes and an audio signal sounds.
/
This signals that warnings (e.g.
theft, anti-drift, calibration) will not be
shown and the measuring tool will no
longer be remote-controlled.
– Press the audio signal/volume
button 24 repeatedly until the
desired setting is reached.
No indicator: audio signal off
/
Normal audio signal
Loud audio signal
– Press the measuring accuracy
setting button 23 repeatedly until
/
/
/
/
/
/
12/8/15 2:53 PM