User Menu; Pellet Feed Adjustment; Stand-By - Dal Zotto Edy Manual Del Usuario

Ocultar thumbs Ver también para Edy:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

user menu

pelleT feeD aDjusTmenT

The following menu allows the pellet feed percentage to be adjusted.
if the stove has functioning problems due to the quantity of pellets, adjust pellet feeding directly from the control panel.
The problems related to the amount of fuel can be divided into 2 categories:
NO FUel:
Š the stove can never develop a suitable flame, tending to remain very low even at high power.
Š at minimum power the stove tends to almost switch-off bringing the stove to the "NO pelleT" alarm condition.
Š when the stove displays the "NO pelleT" alarm, there may be non-burned pellets inside the burn pot.
exCess FUel:
Š the stove develops a very high flame even at low power.
Š the panoramic glass is very dirty, obscuring it almost totally.
Š the burn pot tends to become encrusted, blocking the holes for air intake due to the excessive pellet feed, as it is only partially burned.
The adjustment to be performed is in percentage. Therefore changing this parameter will lead to a proportional variation of all stove feeding
speeds. Feeding is from -30% to +20%.
Follow the procedure on the display to perform the procedure:
CONTrOls prOCeDUre
Š press key 5 for a few seconds, until seT ClOCK appears.
Š press key 3 several times to reach seT User.
Š Confirm using key 5.
Š pellet is displayed.
Š Using key 2 and 3 it is possible to increase(3) or decrease (2) feeding during the OperaNT phase
Š press key 1 several times to confirm and exit the menu.

sTanD-by

The sTBy function is used if immediate stove switch-off is required when the set temperature has been
reached.
The sTBy function can be set at ON or OFF using the procedure described further on.
in the factory the sTby function is always set at off (indicator off)
sTby funcTIon seT aT on
if the sTBy function is active (ON), when the stove reaches the set room temperature and exceeds it by 2°C, it will switch off after a default
delay time, displaying sTaND - By.
when the room temperature is 2°C lower than the setting, the stove will start to work again at the power set on the display, displaying
OperaNT.
sTby funcTIon seT aT off (defaulT seTTIng)
if the stby function is not active (OFF), if the stove reaches the set room temperature, it will go to minimum, modulating and displaying
mODUlaTiON. when the room temperature is below the setting, it will start to work again at the set power, displaying OperaNT.
CONTrOls prOCeDUre
Š press key 5 for a few seconds, until seT ClOCK appears.
Š press key 3 until "User" appears.
Š press key 5 twice.
Š Use key 2 or 3 "ON" to activate or "OFF" to de-activaate.
Š press key 1 several times to confirm and exit the menu.
40
ENGLISH
Tabla de contenido
loading

Este manual también es adecuado para:

GabryGabry eliteStefyRitaRita elite

Tabla de contenido