Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Never use the Nailer in sites containing
lacquer, paint, benzine, thinner, gasoline,
gases, adhesive agents, and other materials
which are combustible or explosive.
11. KEEP VISITORS AWAY.
Do not let visitors handle the Nailer.
All visitors should be kept safely away from
work area.
12. DRESS PROPERLY.
Do not wear loose clothing or jewelry as
they can be caught in moving parts.
Rubber gloves and nonskid footwear are
recommended when working outdoors.
Wear protective hair covering to contain
long hair.
13. NEVER USE NON RELIEVING COUPLER
ON NAILER.
If a non relieving coupler is used on the
Nailer, the Nailer can remain charged
with air after disconnecting and thus
will be able to drive a fastener even after
disconnecting.
The Nailer and air hose must have a hose
coupling such that all pressure is removed
from the Nailer when the coupling joint is
disconnected.
14. CHECK DOUBLE TRIGGER BEFORE
USE.
The Nailer will not operate unless you pull
the lock lever before you pull the trigger.
Make sure the lock lever operates properly.
(The lock lever may be called "Safety".)
Never use the Nailer unless the lock lever
is operating properly, otherwise the Nailer
could drive a fastener unexpectedly.
Do not tamper with or remove the lock
lever, otherwise the lock lever becomes
inoperable.
With no nails loaded in the Nailer, connect
the air hose and check the following.
○
There is no operating noise from the
piston inside the Nailer when the
trigger is pulled without fi rst pulling the
lock lever.
Using the Nailer when it is not operating
normally may lead to injury. If any
abnormality occurs, contact the dealer
where the Nailer was purchased or your
nearest Hitachi authorized service center
and arrange for repairs.
SAFETY
- Continued
15. KEEP ALL SCREWS AND COVERS
TIGHTLY IN PLACE.
Keep all screws and covers tightly mounted.
Check their condition periodically.
Never use the Nailer if parts are missing or
damaged.
16. DO NOT LOAD FASTENERS WITH
TRIGGER OR LOCK LEVER PULLED.
When loading fasteners into the Nailer or
when connecting the air hose,
1) do not pull the trigger;
2) do not pull the lock lever; and
3) keep the Nailer pointed downward.
17. KEEP FACE, HANDS AND FEET AWAY
FROM FIRING HEAD AT ALL TIMES.
Never place your face, hands or feet near
the fi ring head.
18. PLACE
WORKPIECE.
Do not drive fasteners on top of other
fasteners or with the Nailer at too steep of
an angle; the fasteners can ricochet and
hurt someone.
19. BEWARE OF RECOIL.
When driving a nail into a hard workpiece,
the Nailer may rebound. Be sure to keep
your face away from the Nailer.
20. DO NOT DRIVE FASTENERS INTO THIN
BOARDS OR NEAR CORNERS AND
EDGES OF WORKPIECE.
The fasteners can be driven through
or away from the workpiece and hit
someone.
21. NEVER
BOTH SIDES OF A WALL AT THE SAME
TIME.
The fasteners can be driven into and
through the wall and hit a person on the
opposite side.
22. CHECK FOR LIVE WIRES.
Avoid the risk of severe electrical shock by
checking for live electrical wires that may
be hidden by walls, fl oors or ceilings. Turn
off the breaker switch to ensure there are
no live wires.
23. NEVER CARRY NAILER BY HOSE.
24. DO NOT OVERREACH.
Keep proper footing and balance at all
times.
NAILER
PROPERLY
DRIVE
FASTENERS
English
ON
FROM
5
Tabla de contenido
