Maintenance; General Regulations; Replacement Of The Flywheels' Coatings; Iii. Replacement Of The Bench Inlay - Fox F28-186A Manual De Instrucciones

5. Move the part (49) in order that the wheels (29) are about 1 mm behind teeth's base. Tighten firmly
screw (40).
6. Loosen hex head screws (38) .
7. Push the two wheels (29) in the direction of the saw blade until they come in contact with the saw
blade (saw blade musn't get stuck).
8. Tighten hex head screws (38).
9. Make the upper wheel (7) rotate clockwise by hand in order to place the wheels correctly (they must
touch lightly the saw blade).
10. After finishing adjustment operations, close the saw blade protection (34).
DANGER!
Before performing any adjustment or maintenance task and before changing
the blade you must switch off the machine, disconnect it from the power supply and
wait for the saw blade to stop.
I. General regulations
In case you find out any damage to the protection devices or irregularities while processing
or checking the machine, you must get it repaired immediately by qualified persons.
Before use check that the protection and safety devices are perfectly efficient. After carrying
out the work, make a general cleaning of the machine by removing dust and chips.
Do not use any thinner to clean plastic pieces. Most of the kinds of plastic risk to get
damaged by commercially available thinners. Use a clean cloth to remove impurities, dust,
etc.
Extract periodically sawdust that can pile up inside the machine by opening the two doors.
Clean also the ventilation inlets of the engine.
Be sure that the protective cap can slide freely.
Periodically check the tensioning and the conditions of the belt.
Periodically check the conditions of the flywheels' coatings.
Periodically check bench inlay's conditions.
II. Replacement of the flywheels' coatings FIG.17
Regularly check the flywheels' coatings and if necessary change both of them:
1. remove the saw blade (see previous paragraphs);
2. let a small screwdriver slide under the coatings and remove them;
3. place the new plastic coatings and re-assemble the saw blade.

III. Replacement of the bench inlay

The bench inlay must be changed when the hole for the passage of the blade is damaged.
1. remove the bench inlay (80) from the workbench by pushing from below.
2. Insert a new bench inlay.
39