STOK GridIron STG1050 Manual Del Operador página 17

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

 Once burner tube is clear of debris, use a wire brush to
remove food and dirt from the outer surface of the tubes.
 Check burner for damage. Normal wear and corrosion
may cause some holes to enlarge. Replace burner if this
happens.
NOTE: Burner tube must reengage valve opening.
 Verify that the gas valve orifice is correctly positioned
inside burner inlet.
 Attach the electrode to the burner and carefully replace
the burner.
 Slide burner into the grill and secure burner using wing
nuts.
 Reattach electrode wires to the electronic ignitor.
BURNER FLAME CHECK
See Figure 23.
 Open the firebox hood and allow grill to cool completely.
 Turn control knob to OFF ( O ).
NOTE: To lock the control knob in the off position, turn
the control knob to LOCK (
 Remove grates.
 Light burner and turn the control knob from high to low.
A smaller flame should been seen on low while the high
positions flame should be approximately 1/2 in. in height.
 If only a low flame is seen, you may need to reset
the gas regulator safety device as described in the
Operation section.
Fig. 23
MAINTENANCE
).
HIGH
LOW
17 — English
IGNITOR CHECK
Remove LP gas cylinder completely. Press and hold the
ignitor. "Click" should be heard and a spark seen between
the burner and electrode. If no spark, see the Troubleshoot-
ing section later in this manual.
VALVE CHECK
Remove LP gas cylinder completely. Control knob locks in
place when turned off. To check valves: push in knobs and
release. If knobs don't spring back, replace the valve
assembly before using grill.
STORING THE GRILL
See Figure 24.
 Turn the control knob to OFF ( O ).
NOTE: To lock the control knob in the off position, turn
the control knob to LOCK (
 Remove LP gas cylinder.
 Place dust cap on cylinder valve outlet whenever the
cylinder is not in use. Only install the type of dust cap on
the cylinder valve outlet that is provided with the cylinder
valve. Other types of caps or plugs may result in leakage
of propane.
 Once cooled, clean grill thoroughly.
 Store in dry location. If storing outside, cover grill with
one of the variety of grill covers offered by STOK or other
grill cover manufacturers.
Fig. 24
).
Tabla de contenido
loading

Tabla de contenido