Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Fig. S
Adjusting the Fence (Fig. T)
The upper part of the fence can be adjusted to provide
clearance, allowing the saw to bevel to 45° left and 0° right.
To adjust the left fence
22
1. Loosen the left side fence clamping knob
the fence to the left.
2. Make a dry run with the saw switched off and check for
clearance. Adjust the fence to be as close to the blade
as practical to provide maximum workpiece support,
without interfering with the up and down movement
of the arm.
3. Tighten the knob securely.
WARNING: The guide grooves
clogged with sawdust. Use a stick or some low
pressure air to clear the guide grooves.
Fig. T
11
52
50
51
17
:
11
and slide
52
can become
22
Checking and Adjusting the Bevel Angle
(Fig. T, U)
1. Loosen the left side fence clamping knob
the upper part of the left side fence to the left as far as
it will go.
2. Loosen the bevel clamp knob
arm to the left until the angle position stop
the bevel position adjustment stop
bevel position.
If adjustment is required, proceed as follows:
3. Loosen the locknut
49
a few turns and turn the bevel
position adjustment stop screw
pointer
indicates 45° with the angle position stop
50
resting on the bevel position adjustment stop.
26
4. Firmly tighten the lock nut
screw
27
stationary.
5. To achieve a 0° right bevel or a 45° left bevel, the two
adjustment stop screws must be adjusted to allow the
saw arm to move as necessary.
Fig. U
26
27
49
Adjusting the Depth Stop (Groove Cuts)
(Fig. V)
The depth stop adjustment screw
clockwise to reach the desired depth of cut for grooves.
1. Tilt the saw head to the desired position for the
groove cut.
2. Turn the adjustment screw
of the screw touches the housing stop.
3. Guide the tool head slowly upward.
NoTE: aFTER THE GRooVE CUT Is CoMplETE RETURN
THE DEpTH sTop aDJUsTMENT sCREW To THE
oRIGINal posITIoN.
NoTE: ENsURE THaT THE saW BlaDEs Do NoT ToUCH
aNY paRT oF THE BasE oR KERF plaTE.
Fig. V
45
ENGlIsH
11
and slide
16
and move the saw
rests on
26
. This is the 45°
27
27
in or out until the
while holding the stop
49
16
50
45
can be turned
clockwise until the end
45
53
Tabla de contenido
