DeWalt DW714 Manual De Instrucciones página 58

ENGlIsH
(80–120 tooth carbide) blade and a slower for aluminum,
even cutting rate will produce the desired results.

WARNING: Ensure that the material does not creep
while cutting; clamp it securely in place. Always let
the blade come to a full stop before raising the arm.
If small fibres of wood still split out at the rear of the
workpiece, stick a piece of masking tape on the wood
where the cut will be made. Saw through the tape and
carefully remove tape when finished.
Clamping the Workpiece (Fig. C, AA, BB)
1. Whenever possible, clamp the wood/ aluminum to
the saw.
2. For best results use the clamp
your saw. Clamp the workpiece to the fence whenever
possible. You can clamp to either side of the saw blade;
remember to position your clamp against a solid, flat
surface of fence.
Mounting the clamp (Fig. AA):
1. Inserting the vertical clamp
shown in Figure AA, then rotate to the right position.
If horizontal clamp is needed, insert the horizontal clamp
into holes 43 as shown in Figure BB.

WARNING: Always use a material clamp when
cutting non-ferrous metals.

WARNING: Always use both of vertical clamp and
horizontal clamp when cutting small pieces.
Fig. AA
33
39
56
33 made for use with
into the holes as
33 39
39
Fig. BB
43
43
Support for Long Pieces (Fig. C, CC)
1. Always support long pieces.
2. For best results, use the extension work support
35 to extend the table width of your saw. Support
long workpieces using any convenient means such
as saw-horses or similar devices to keep the ends
from dropping.
43
43