Glass Cooktop - Haier QAS740 Manual Del Usuario

CARE AND CLEANING

GLASS COOKTOP

Normal Daily Use Cleaning
ONLY use CERAMA BRYTE® Ceramic Cooktop Cleaner on
the glass cooktop. Other creams may not be as effective.
To maintain and protect the surface of your glass cooktop,
follow these steps:
1. Before using the cooktop for the first time, clean it with
CERAMA BRYTE® Ceramic Cooktop Cleaner. This helps
protect the top and makes cleanup easier.
2. Before using the cooktop for the first time, clean it with
CERAMA BRYTE® Ceramic Cooktop Cleaner. This helps
protect the top and makes cleanup easier.
3. Shake the cleaning cream well. Apply a few drops of
CERAMA BRYTE® Ceramic Cooktop Cleaner directly to
the cooktop.
4. Use a paper towel or
CERAMA BRYTE® Cleaning
Pad for Ceramic Cooktops
to clean the entire cooktop
surface.
5. Use a dry cloth or paper
towel to remove all cleaning
residue. No need to rinse.
NOTE: It is very important that
you DO NOT heat the cooktop
until it has been cleaned
thoroughly.
Burned-On Residue
NOTE: DAMAGE to your glass surface may occur if you use
scrub pads other than those recommended.
1. Allow the cooktop to cool.
2. Spread a few drops of CERAMA BRYTE® Ceramic
Cooktop Cleaner on the entire burned residue area.
3. Using the included CERAMA BRYTE® Cleaning Pad
for Ceramic Cooktops, rub the residue area, applying
pressure as needed.
4. If any residue remains, repeat the steps listed above as
needed.
5. For additional protection, after all residue has been
removed, polish the entire surface with CERAMA
BRYTE® Ceramic Cooktop Cleaner and a paper towel.
Cleaning Pad for Ceramic Cooktops.
®
49-88074-1
Clean your cooktop after each
spill. Use CERAMA BRYTE
®
Ceramic Cooktop Cleaner.
Heavy, Burned-On Residue
1. Allow the cooktop to cool.
2. Use a single-edge razor blade scraper at approximately a
45° angle against the glass surface and scrape the soil. It
will be necessary to apply pressure to the razor scraper
in order to remove the residue.
3. After scraping with the razor scraper, spread a few drops
of CERAMA BRYTE® Ceramic Cooktop Cleaner on the
entire burned residue area. Use the CERAMA BRYTE®
Cleaning Pad to remove any remaining residue.
4. For additional protection, after all residue has been
removed, polish the entire surface with CERAMA
BRYTE® Ceramic Cooktop Cleaner and a paper towel.
Ceramic Cooktop Scraper and all
®
recommended supplies are available through our Parts Center.
See instructions under "To Order Parts" section on next page.
NOTE: Do not use a dull or nicked blade.
Metal Marks and Scratches
1. Be careful not to slide pots and pans across your cooktop.
It will leave metal markings on the cooktop surface.
These marks are removable using the CERAMA BRYTE®
Ceramic Cooktop Cleaner with the CERAMA BRYTE®
Cleaning Pad for Ceramic Cooktops.
2. If pots with a thin overlay of aluminum or copper
are allowed to boil dry, the overlay may leave black
discoloration on the cooktop.
This should be removed immediately before heating
again or the discoloration may be permanent.
NOTE: Carefully check the bottom of pans for roughness
that would scratch the cooktop.
17