Initial Settings - Hama EWS-820 Instrucciones De Uso

6.1. Initial settings

• After inserting the batteries, a value indicating the height in metres (15) will flash.
• Set the following information in the order listed:
• height of the location, symbol for the current weather conditions, atmospheric pressure unit (hPa/ inhg)
• To select the individual values, press the + button (27) or the – button (28) and confirm each selection by
pressing the HISTORY button (29). .
• The standard settings are retained if you do not make an entry within 20 seconds. You can subsequently
change/reset these values at any time as described in 6.4. Basic and manual settings.
6.2. Connection to the measuring station
• After making initial settings, the base station automatically searches for a connection to the measuring
station and performs initial setup.
Note
• Initial setup takes approx. 3 minutes.
• Do not press any buttons during setup. Otherwise, values may not be transmitted correctly and there is a
risk of value errors and inaccuracies.
• The setup process is completed when the indoor (9, 10) and outdoor (18, 20) measurement data is
displayed.
• If the base station still does not receive a signal from the measuring station, press and hold the CHANNEL
button (30) for approx. 3 seconds to start the manual search for the signal.
6.3. Selecting the channel/other measuring stations
Note
You can install two more measuring stations in addition to the included measuring station. Ensure that the
base and measuring stations are set to the same channel.
Visit www.hama.com for suitable measuring stations.
• Press the CHANNEL button (30) repeatedly to set the channel to that set on the respective measuring
station – see 4.1. Measuring station . 1, 2, 3 (23) or Channel overview
• The base station now shows the data measured (18, 20) on the selected measuring station (23).
• Select Channel overview
channels consecutively for 5 seconds each.
6.4. Basic and manual settings
Automatic setting using the DCF signal
• After the first time the base station is switched on and successful transmission is established between the
base station and the measuring station, the clock will automatically search for a DCF signal. During the
search, the wireless symbol (5) will flash.
6
(18) to show the measurement values of the individual measuring stations/
(18) is displayed.