Removing And Fitting The Appliance Door; Cleaning The Hook-In Racks; Troubleshooting - Siemens HB933R51 Instrucciones De Uso

Removing and fitting the appliance door

You can remove the appliance door to clean it more
thoroughly.
Removing the appliance door
:
Risk of injury!
Whenever the hinges are not locked, they snap shut with great
force. Make sure that, when unhooking the oven door, the
locking levers are folded up completely.
Open the oven door completely.
1.
Fold up the left and right locking levers. Make sure that, when
2.
the locking levers are folded up, you do not close the oven
door. The hinges may become bent which may cause
damage to the enamel.
Open the oven door at an angle. Hold it on the right and left
3.
with both hands. Close it just a little further and pull it out.
Fitting the appliance door
When hooking in the oven door, ensure that the notch on the
1.
bottom of the hinge locks into the slot.
Fold down both locking levers on the left and right again and
2.
close the oven door.

Troubleshooting

Malfunctions often have simple explanations. Please read the
following notes before calling the after­sales service.
Problem Possible cause Notes/remedy
The appliance Circuit breaker
does not work. faulty.
Power cut
The oven The electronics
cannot be are faulty.
switched off.
The clock Power cut
display flashes.
The oven does Circuit breaker
not heat up. faulty.
Look in the fuse box and
check that the circuit
breaker for the cooker is in
working order.
Check whether the kitchen
light works.
Switch off the circuit
breaker. Contact the
after-sales service.
Reset the clock.
Check the circuit breaker
and replace if necessary.
:
Risk of injury!
Do not reach into the hinge if the oven door falls out
unintentionally or a hinge snaps closed. Call the after­sales
service.

Cleaning the hook-in racks

You can remove the hook-in racks for easier cleaning.
The hook-in racks in each case are fixed to the side walls of the
cooking compartment at three points.
Removing the hook-in racks
Lift the front hook out of the hole.
1.
Pull the hook-in rack forwards out of the rear holes.
2.
Cleaning the hook-in racks
Clean the hook-in racks with washing-up liquid and a sponge or
brush.
Inserting the hook-in rack
Insert the hook-in rack into the holes in the back wall.
1.
Hook the front hook into the hole.
2.
Problem Possible cause Notes/remedy
The function
selector has not
been set.
The door glass
is broken.
Fruit juice or Moist cake or
albumen stains meat juices.
on enamelled
surfaces.
:
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Incorrect repairs may result in significant risk to the user.
Set the function selector.
Switch off the appliance.
Contact the after-sales
service.
Harmless change in the
enamel, cannot be
removed.
21