Attachment At The Wall/Ceiling; Connection With The Mains; Adjusting The Laser; Operation - EuroLite LAS-7 Showlaser Manual Del Usuario

5.3 Attachment at the wall/ceiling

Do only use appropriate screws and make sure that the screws are properly connected with the ground.
The durability of the installation depends very much on the material used at the installation area (building
material) such as wood, concrete, gas concrete, brick etc. This is why the fixing material must be chosen to
suit the wall material. Always ask a specialist for the correct plug/screw combination indicating the maximum
load and the building material.

5.4 Connection with the mains

Connect the connection cable of the power-unit with the DC IN-socket. Plug the power unit into your outlet.
Showlasers must provide a manual safety shutdown enabling to interrupt the laser radiation at any time by
force. If the laser product is installed in the trussing system or in an unaccessible location, it must at least be
installed with a switchable power outlet.
DANGER TO LIFE!
Before taking into operation for the first time, the installation has to be approved by an expert!

5.5 Adjusting the laser

Switch the device on via the power switch.
Loosen the fixation screws of the hanging-bracket and adjust the laser product to the desired projection area.
Call up all desired projection patterns in order to make sure that the projections only move in the
inaccessible showlaser area.
Make sure that no mirrorballs, shining surfaces etc. are located in the laser beam. Shining objects must be
removed from the laser area or be covered.
Tighten the fixation screws of the hanging-bracket so that the laser beam cannot be moved without tools.

6. OPERATION

With the POWER-switch, you can switch the device on and off.
In the AUTO-mode, the 16 patterns are run automatically. You can adjust the speed with the AUTO SPEED-
control.
In the MUSIC-mode, the laser runs sound-controlled.
In the MANUAL-mode, the direction of the rotation, the rotation speed and the distortion can be adjusted.
Spatial effects of the projection patterns can be created by using a smoke-machine. Make sure that you do
not use too much smoke so that the laser beam is swallowed after a short distance and the audience cannot
see the projections.

7. CLEANING AND MAINTENANCE

Laser products in discotheques are technical Lasereinrichtungen in Diskotheken sind technische working
installations and fall under the Equipment Safety Act. This is why they must fulfill its requirements.
The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
25/49 51741140_V_1_0.DOC