Use Of The Function "Adjustable Vacuum Strength; Use Of The Function "Selectable Welding Time - Caso VC300 PRO Instrucciones De Funcionamiento Originales

Use of the function "Adjustable vacuum strength"

16.7

Use of the function "selectable welding time"

16.8
caso VC300 Pro
Since the pressure of the vacuuming becomes too strong for
specific foods and these could be crushed in the bag, you can
adjust the length and strength of the vacuuming process via the
function "Adjustable Vacuum strength". So you can adjust the
vacuum strength to the consistency of your vacuum food and
also seal soft foods (for example berry fruit) without crushing
them.
Due to the time and pressure control, the crushing of delicate
foods is prevented. You can also use this function for the
packaging of juicy foods to prevent that fluids are aspirated and
drawn out.
Adjustable Vacuum strength
7. Put the foods you want to store into the bag.
8. Clean and smooth the open end of the bag and be sure that
there are no folds or waves on the surfaces of the open ends.
9. Be sure that the open end of the bag is within the vacuum
chamber seal. This guarantees that there is no escape of the
vacuum.
10. Close the cover and firmly press it down on both sides until you
hear two "clicks".
11. Press the button "Vakuumstärke". As long as you press the
button, air is withdrawn. Only when you release the button, the
process stops. Thus you can exactly control the vacuum and
prevent the liquid from being sucked. Please hold the button
pressed until the required vacuum has been reached.
12. Then press the button "Schweißen" and seal the bag.
** Press the button "Stop" to interrupt the process.
When there are fluids in the bag and hence in the section where
you want to seal it, the welding procedure should be adjusted to
"feucht". This would increase the welding time and the bag is
safely sealed. Press the button "Trocken & Feucht". If the lamp
will illuminate above "feucht", the welding time for moist
vacuum food is adjusted.
► Do not put too much food inside the bag; leave enough
empty length in the open end of the bag so that the bag can
be placed in the vacuuming plate more positively.
► Do not wet the open end of the bag. Wet bags may be
difficult to seal tightly.
Please note
56