Tabla De Contenido; Introduction - Husqvarna T 7500 Manual Del Usuario

Introduction..................................................................... 2
Safety..............................................................................6
Assembly........................................................................ 8
Accessories.................................................................... 8
Operation........................................................................ 9
Owner responsibility
WARNING: Cutting, especially when DRY
cutting, generates dust that comes from the
material being cut, which frequently contains
silica. Silica is a basic component of sand,
quartz, brick clay, granite and numerous
other minerals and rocks. Exposure to
excessive amount of such dust can cause:
Respiratory disease (affecting your ability to
breathe), including chronic bronchitis,
silicosis and pulmonary fibrosis from
exposure to silica. These diseases may be
fatal;
Skin irritation and rash.
Cancer according to NTP* and IARC* */
National Toxicology Program, International
Agency for Research on Cancer.
Take precautionary steps:
Avoid inhalation of and skin contact with
dust, mist and fumes.
Wear and ensure that all bystanders wear
appropriate respiratory protection such as
dust masks designed to filter out
microscopic particles. (See OSHA 29 CFR
Part 1926.1153)
To minimize dust emissions, wet cut when
feasible. If dry cutting is necessary, use an
appropriate dust extractor.
It is the owner's/employer's responsibility that the
operator has sufficient knowledge about how to use the
product safely. Supervisors and operators must have
read and understood the Operator's Manual. They must
be aware of:
2
Contents
Maintenance................................................................... 9
Troubleshooting............................................................ 12
Transportation, storage and disposal........................... 13
Technical data.............................................................. 14
Warranty....................................................................... 14

Introduction

• The products's safety instructions.
• The products's range of applications and limitations.
• How the product is to be used and maintained.
National/Local regulations could restrict the use of this
product. Find out what regulations are applicable where
you work before you start using the product.
Product description
The product is a dust extractor with a suction hose. Air
with dust is suctioned into an inlet valve through the
suction hose. The air decreases in speed by a cyclone
which cause the dust particles to move apart from the
air. Small dust particles and air goes through a 2 filter
system. Large dust particles are collected in the cyclone
and fall through the bottom flap into a plastic bag.
Intended use
The T-Line Dust Extractor is used to clean construction
areas by collecting up dry and non flammable dust in
indoor environments.
The T-Line Dust Extractor can be connected to medium
and large surface preparation equipment such as
grinders.
The T-Line Dust Extractor is intended for commercial
use, for example in hotels, schools, hospitals, factories,
shops, offices and rental businesses
Note: The explosion limit value for the not flammable
dust is >0.1mg/m
Dust storage system
All Husqvarna T-Line Dust Extractors are to be used
with Longopac. Only change Longopac after the filter
cleaning cycle has been completed.
3
.
877 - 003 -